Show simple item record

dc.contributor.authorYavuz Kadioglu
dc.contributor.authorHuseyin Sehitoglu
dc.date.accessioned2017-05-08T23:50:24Z
dc.date.available2017-05-08T23:50:24Z
dc.date.copyrightJanuary, 1996
dc.date.issued1996
dc.identifier.issn0094-4289
dc.identifier.otherJEMTA8-26976#94_1.pdf
dc.identifier.urihttp://yetl.yabesh.ir/yetl/handle/yetl/117083
dc.description.abstractThermomechanical fatigue (TMF) and isothermal fatigue (IF) experiments were performed on bare Mar-M246 as well as bare and coated Mar-M247 nickel based superalloys at strain ranges from 0.335 to 1 percent. The experiments were conducted in air, through a temperature range of 500 to 1038°C at a constant strain rate of 5.0 × 10-5 s-1 . Due to the coarse-grained structure of Mar-M246, TMF lives scattered considerably under low strain range conditions. Electron microscopy studies show that significant surface oxidation and gamma prime, γ′, depleted zones occur for Mar-M246 under these conditions. In the surface grain, where the change in γ′ morphology is most pronounced, γ′ rafted along axes ≈ ±45 deg from the loading axis. The influence of a protective coating on the IF and TMF lives of Mar-M247 was also examined. Results indicate that the coating does not significantly affect the fatigue lives of Mar-M247. The oxidation behavior of bare and coated Mar-M247 was investigated via X-ray microprobe and Auger Spectroscopy. Through these analyses, it is evident that the coating was completely degraded when exposed to the test environment for a long time. In both Mar-M246 and Mar-M247, in-phase thermomechanical fatigue (TMF IP) loading resulted in intergranular cracking. TMF IP loading promoted multiple cracks at the coating/substrate interface of coated Mar-M247. Finally, Eshelby techniques were used to calculate stress distributions in the vicinity of a surface oxide and second-phase particle at the coating/substrate interface.
dc.publisherThe American Society of Mechanical Engineers (ASME)
dc.titleThermomechanical and Isothermal Fatigue Behavior of Bare and Coated Superalloys
dc.typeJournal Paper
dc.journal.volume118
dc.journal.issue1
dc.journal.titleJournal of Engineering Materials and Technology
dc.identifier.doi10.1115/1.2805939
dc.journal.fristpage94
dc.journal.lastpage102
dc.identifier.eissn1528-8889
dc.keywordsFatigue
dc.keywordsSuperalloys
dc.keywordsCoating processes
dc.keywordsCoatings
dc.keywordsoxidation
dc.keywordsProtective coatings
dc.keywordsElectron microscopy
dc.keywordsStress
dc.keywordsAugers
dc.keywordsFracture (Materials)
dc.keywordsFracture (Process)
dc.keywordsSpectroscopy
dc.keywordsParticulate matter
dc.keywordsTemperature
dc.keywordsX-rays AND Nickel
dc.treeJournal of Engineering Materials and Technology:;1996:;volume( 118 ):;issue: 001
dc.contenttypeFulltext


Files in this item

Thumbnail

This item appears in the following Collection(s)

Show simple item record