Show simple item record

dc.contributor.authorM. P. Miller
dc.contributor.authorD. L. McDowell
dc.date.accessioned2017-05-08T23:50:23Z
dc.date.available2017-05-08T23:50:23Z
dc.date.copyrightJanuary, 1996
dc.date.issued1996
dc.identifier.issn0094-4289
dc.identifier.otherJEMTA8-26976#28_1.pdf
dc.identifier.urihttp://yetl.yabesh.ir/yetl/handle/yetl/117073
dc.description.abstractIn metals, large strain inelastic deformation processes such as the formation of a preferred crystallographic orientation (crystallographic texture) and strain hardening processes such as the formation and evolution of dislocation substructures depend on stress-state. Much of the current large strain research has focused on texture. Crystallographic texture development and strainhardening processes each contribute to the overall material behavior, and a complete description of large strain inelastic material response should reflect both. An investigation of the large strain behavior of 304L stainless steel (SS 304L) subjected to compression, torsion, and sequences of compression followed by torsion and torsion followed by tension is reported. This paper focuses on the stress-state dependence of strain-hardening processes as well as the relative effect such processes have on the overall material behavior. To characterize these processes, transmission electron microscopy (TEM) as well as magnetization investigations were conducted at different strain levels and under different deformation modes. The γ → α′ martensitic transformation which occurs in this material was found to be related to both the strain level and stress state. Dislocation substructures in the form of Taylor lattices, dense dislocation walls, and microbands were also present. The ramifications of using a thin-walled tubular torsion specimen were also explored.
dc.publisherThe American Society of Mechanical Engineers (ASME)
dc.titleThe Effect of Stress-State on the Large Strain Inelastic Deformation Behavior of 304L Stainless Steel
dc.typeJournal Paper
dc.journal.volume118
dc.journal.issue1
dc.journal.titleJournal of Engineering Materials and Technology
dc.identifier.doi10.1115/1.2805930
dc.journal.fristpage28
dc.journal.lastpage36
dc.identifier.eissn1528-8889
dc.keywordsDeformation
dc.keywordsStress
dc.keywordsStainless steel
dc.keywordsTorsion
dc.keywordsTexture (Materials)
dc.keywordsDislocations
dc.keywordsWork hardening
dc.keywordsCompression
dc.keywordsTension
dc.keywordsTransmission electron microscopy
dc.keywordsMagnetization
dc.keywordsMartensitic transformations AND Metals
dc.treeJournal of Engineering Materials and Technology:;1996:;volume( 118 ):;issue: 001
dc.contenttypeFulltext


Files in this item

Thumbnail

This item appears in the following Collection(s)

Show simple item record