Show simple item record

dc.contributor.authorM. G. Yuan
dc.contributor.authorY. Ueda
dc.date.accessioned2017-05-08T23:50:22Z
dc.date.available2017-05-08T23:50:22Z
dc.date.copyrightApril, 1996
dc.date.issued1996
dc.identifier.issn0094-4289
dc.identifier.otherJEMTA8-26978#229_1.pdf
dc.identifier.urihttp://yetl.yabesh.ir/yetl/handle/yetl/117064
dc.description.abstractIn order to develop a predicting method of residual stresses in fillet welded T- and I-joints, a concept of inherent strain, being regarded as a source of the residual stresses, was introduced. With the proposed method, the residual stress of an interested weldment may be predicted by performing an elastic analysis, in which the inherent strain is replaced to equivalent distributed loads. The inherent strain distributions in various welded T- and I-joints were investigated by numerical simulations. The results showed that the inherent strains distributing in flange side and in web side of the several joints are almost the same. The inherent strains vary not only with the average temperature rise due to welding, but with the geometric ratio of the joints. Being simplified by a trapezoid curve, the inherent strain distribution in a fillet weld was expressed by formulas, in which heat input, material properties, and geometric dimensions were taken into account. Welding residual stresses in T- and I-joints, predicted by the proposed method employing the derived formulas, were compared with those obtained by thermal elasto-plastic analysis, and good agreement was recognized. The validity of the proposed method was also confirmed by experiments.
dc.publisherThe American Society of Mechanical Engineers (ASME)
dc.titlePrediction of Residual Stresses in Welded T- and I-Joints Using Inherent Strains
dc.typeJournal Paper
dc.journal.volume118
dc.journal.issue2
dc.journal.titleJournal of Engineering Materials and Technology
dc.identifier.doi10.1115/1.2804892
dc.journal.fristpage229
dc.journal.lastpage234
dc.identifier.eissn1528-8889
dc.keywordsResidual stresses
dc.keywordsStress
dc.keywordsWelding
dc.keywordsFormulas
dc.keywordsElastic analysis
dc.keywordsComputer simulation
dc.keywordsDimensions
dc.keywordsHeat
dc.keywordsTemperature
dc.keywordsFlanges AND Materials properties
dc.treeJournal of Engineering Materials and Technology:;1996:;volume( 118 ):;issue: 002
dc.contenttypeFulltext


Files in this item

Thumbnail

This item appears in the following Collection(s)

Show simple item record