Show simple item record

dc.contributor.authorGwo-Lianq Chern
dc.contributor.authorDavid A. Dornfeld
dc.date.accessioned2017-05-08T23:50:21Z
dc.date.available2017-05-08T23:50:21Z
dc.date.copyrightApril, 1996
dc.date.issued1996
dc.identifier.issn0094-4289
dc.identifier.otherJEMTA8-26978#201_1.pdf
dc.identifier.urihttp://yetl.yabesh.ir/yetl/handle/yetl/117059
dc.description.abstractThe mechanisms of burr formation and breakout in orthogonal cutting are analyzed. A burr formation/breakout model for orthogonal cutting is proposed, based on the observation of SEM micro-machining tests. It is found that a negative deformation plane begins to form when the steady-state chip formation stops as the tool approaches the end of the cut. Plastic bending and shearing of the negative deformation plane contributes to the burr formation, while crack propagation along the plane causes the breakout. Simulated orthogonal cutting experiments using copper, Al 2024-T4, and Al 6061-T6 were performed with a modified impact machine to verify the model. The tests showed excellent agreement with the model predictions.
dc.publisherThe American Society of Mechanical Engineers (ASME)
dc.titleBurr/Breakout Model Development and Experimental Verification
dc.typeJournal Paper
dc.journal.volume118
dc.journal.issue2
dc.journal.titleJournal of Engineering Materials and Technology
dc.identifier.doi10.1115/1.2804887
dc.journal.fristpage201
dc.journal.lastpage206
dc.identifier.eissn1528-8889
dc.keywordsDeformation
dc.keywordsCopper
dc.keywordsMachinery
dc.keywordsCrack propagation
dc.keywordsCutting
dc.keywordsMicromachining
dc.keywordsModel development
dc.keywordsShearing
dc.keywordsSteady state AND Mechanisms
dc.treeJournal of Engineering Materials and Technology:;1996:;volume( 118 ):;issue: 002
dc.contenttypeFulltext


Files in this item

Thumbnail

This item appears in the following Collection(s)

Show simple item record