Show simple item record

dc.contributor.authorT. J. Strakna
dc.contributor.authorR. L Allor
dc.contributor.authorK. V. Kumar
dc.contributor.authorS. Jahanmir
dc.date.accessioned2017-05-08T23:50:18Z
dc.date.available2017-05-08T23:50:18Z
dc.date.copyrightJuly, 1996
dc.date.issued1996
dc.identifier.issn0094-4289
dc.identifier.otherJEMTA8-26979#335_1.pdf
dc.identifier.urihttp://yetl.yabesh.ir/yetl/handle/yetl/117033
dc.description.abstractIt is generally found that grinding transverse to the tensile stress direction in flexure bars subjected to four-point bending results in a lower strength compared to grinding in the longitudinal direction. In the present study, standard flexure specimens made from a reaction-bonded and a sintered reaction-bonded silicon nitride (RBSN and SRBSN) were surface ground under three different conditions in both longitudinal and transverse directions to assess the effect of grinding direction on strength. Four-point flexure tests were performed on the specimens and Weibull parameters were calculated. The results showed that while the strength was not affected by the grinding condition when grinding was performed in the longitudinal direction, the strength of the samples ground in the transverse direction was reduced as the material removal rate was increased by a factor of 30. This result was confirmed by fractography, which showed that almost all the fracture initiation sites in the longitudinally ground samples were associated with near-surface microstructural features, whereas in the transverse ground samples fracture initiated from damage introduced by grinding. The strength reduction by grinding in the transverse direction was found to be material dependent, and was larger for SRBSN than for RBSN.
dc.publisherThe American Society of Mechanical Engineers (ASME)
dc.titleInfluence of Grinding Direction on Fracture Strength of Silicon Nitride
dc.typeJournal Paper
dc.journal.volume118
dc.journal.issue3
dc.journal.titleJournal of Engineering Materials and Technology
dc.identifier.doi10.1115/1.2806815
dc.journal.fristpage335
dc.journal.lastpage342
dc.identifier.eissn1528-8889
dc.keywordsGrinding
dc.keywordsSilicon nitride ceramics AND Fracture (Process)
dc.treeJournal of Engineering Materials and Technology:;1996:;volume( 118 ):;issue: 003
dc.contenttypeFulltext


Files in this item

Thumbnail

This item appears in the following Collection(s)

Show simple item record