Show simple item record

dc.contributor.authorR. H. Pant
dc.contributor.authorR. F. Gibson
dc.date.accessioned2017-05-08T23:50:16Z
dc.date.available2017-05-08T23:50:16Z
dc.date.copyrightOctober, 1996
dc.date.issued1996
dc.identifier.issn0094-4289
dc.identifier.otherJEMTA8-26981#554_1.pdf
dc.identifier.urihttp://yetl.yabesh.ir/yetl/handle/yetl/117016
dc.description.abstractThis paper describes the use of a recently developed high temperature impulse-frequency response apparatus to directly measure dynamic modulus and internal damping of high temperature composite materials, matrix materials, and reinforcing fibers as a function of temperature. An extensional vibration test was used for determination of the complex Young’s modulus of fiber specimens as a function of temperature. A flexural vibration test was used for determination of the complex flexural modulus of matrix and unidirectional composite specimens (0 and 90 deg fiber orientations) as a function of temperature. These results were obtained from tests done on two different fiber reinforced composite materials: boron/epoxy (B/E) and Silicon Carbide/Ti-6Al-4V (SiC/Ti). The results from these tests were then used to assess the validity of micromechanics predictions of composite properties at elevated temperatures. Micromechanics predictions of composite moduli and damping at elevated temperatures show good agreement with measured values for the 0 deg case (longitudinal) but only fair agreement for the 90 deg case (transverse). In both cases, the predictions indicate the correct trends in the properties.
dc.publisherThe American Society of Mechanical Engineers (ASME)
dc.titleAnalysis and Testing of Dynamic Micromechanical Behavior of Composite Materials at Elevated Temperatures
dc.typeJournal Paper
dc.journal.volume118
dc.journal.issue4
dc.journal.titleJournal of Engineering Materials and Technology
dc.identifier.doi10.1115/1.2805956
dc.journal.fristpage554
dc.journal.lastpage560
dc.identifier.eissn1528-8889
dc.keywordsTemperature
dc.keywordsComposite materials
dc.keywordsTesting
dc.keywordsFibers
dc.keywordsMicromechanics (Engineering)
dc.keywordsVibration tests
dc.keywordsDamping
dc.keywordsHigh temperature
dc.keywordsSilicon
dc.keywordsElasticity
dc.keywordsImpulse (Physics)
dc.keywordsFiber reinforced composites AND Epoxy adhesives
dc.treeJournal of Engineering Materials and Technology:;1996:;volume( 118 ):;issue: 004
dc.contenttypeFulltext


Files in this item

Thumbnail

This item appears in the following Collection(s)

Show simple item record