Show simple item record

dc.contributor.authorA. K. Gupta
dc.contributor.authorE. Ilanchezhian
dc.contributor.authorE. L. Keating
dc.date.accessioned2017-05-08T23:49:51Z
dc.date.available2017-05-08T23:49:51Z
dc.date.copyrightDecember, 1996
dc.date.issued1996
dc.identifier.issn0195-0738
dc.identifier.otherJERTD2-26468#269_1.pdf
dc.identifier.urihttp://yetl.yabesh.ir/yetl/handle/yetl/116807
dc.description.abstractExperimental and theoretical studies are presented from a laboratory-scale thermal destruction facility on the destruction behavior of surrogate plastic and nonplastic solid wastes. The nonplastic waste was cellulosic, while the plastic waste contained compounds, such as polyethylene, polyvinyl chloride, polystyrene, polypropylene, nylon, rubber, and polyurethane, or any of their desired mixtures. A series of combustion tests was performed with samples containing varying composition test was performed with samples containing varying composition of plastic and nonplastic. Experimental results are presented on combustion parameters (CO, excess air, residence time) and toxic emissions (dioxin, furan, metals). Equilibrium thermochemical calculations are presented on the thermal destruction behavior of samples under conditions of pyrolysis, combustion, and pyrolysis followed by combustion. Special interest is on the effect of waste properties and input operational parameters on chemistry and product composition. STANJAN and SOLGASMIX computer codes were used in the chemical equilibrium study. Analysis and interpretation of the data reveal the effect of waste feed composition on combustion parameters and dioxin, furan, and metals emission. Equilibrium calculation results are used to describe the experimentally observed trends for the thermal destruction behavior of these wastes. The results show significant influence of plastic on combustion characteristics, and dioxin, furan, and metals emission.
dc.publisherThe American Society of Mechanical Engineers (ASME)
dc.titleThermal Destruction Behavior of Plastic and Nonplastic Wastes in a Laboratory-Scale Facility
dc.typeJournal Paper
dc.journal.volume118
dc.journal.issue4
dc.journal.titleJournal of Energy Resources Technology
dc.identifier.doi10.1115/1.2793873
dc.journal.fristpage269
dc.journal.lastpage276
dc.identifier.eissn1528-8994
dc.keywordsCombustion
dc.keywordsMetals
dc.keywordsSolid wastes
dc.keywordsRubber
dc.keywordsNylon fabrics
dc.keywordsUrethane elastomers
dc.keywordsPlastic scrap
dc.keywordsEquilibrium (Physics)
dc.keywordsComputers
dc.keywordsChemistry
dc.keywordsMixtures
dc.keywordsPyrolysis AND Emissions
dc.treeJournal of Energy Resources Technology:;1996:;volume( 118 ):;issue: 004
dc.contenttypeFulltext


Files in this item

Thumbnail

This item appears in the following Collection(s)

Show simple item record