Show simple item record

dc.contributor.authorL. L. Hoberock
dc.contributor.authorG. J. Bratcher
dc.date.accessioned2017-05-08T23:49:51Z
dc.date.available2017-05-08T23:49:51Z
dc.date.copyrightDecember, 1996
dc.date.issued1996
dc.identifier.issn0195-0738
dc.identifier.otherJERTD2-26468#249_1.pdf
dc.identifier.urihttp://yetl.yabesh.ir/yetl/handle/yetl/116804
dc.description.abstractA new method is developed for determining rock strength while drilling with a tri-cone roller bit. The technique employs the well-known “drill-off” test, using commonly measured drilling data, and does not require knowledge of drill bit parameters. The method was evaluated with drill-off test data collected from the Gas Research Institute’s SFE (staged field experiment) well no. 4 and compared with calculated in-situ compressive rock strengths provided by Hareland (1992). The results indicate that the proposed approach produces reasonable results and is easily implemented.
dc.publisherThe American Society of Mechanical Engineers (ASME)
dc.titleA New Approach for Determining In-Situ Rock Strength While Drilling
dc.typeJournal Paper
dc.journal.volume118
dc.journal.issue4
dc.journal.titleJournal of Energy Resources Technology
dc.identifier.doi10.1115/1.2793870
dc.journal.fristpage249
dc.journal.lastpage255
dc.identifier.eissn1528-8994
dc.keywordsDrilling
dc.keywordsRocks
dc.keywordsDrills (Tools)
dc.keywordsRollers
dc.keywordsBits (Tools)
dc.keywordsGaseous fuels research AND Gasoline research
dc.treeJournal of Energy Resources Technology:;1996:;volume( 118 ):;issue: 004
dc.contenttypeFulltext


Files in this item

Thumbnail

This item appears in the following Collection(s)

Show simple item record