Show simple item record

dc.contributor.authorToshikazu Nakanishi
dc.contributor.authorXuegang Yin
dc.contributor.authorA. A. Shabana
dc.date.accessioned2017-05-08T23:49:39Z
dc.date.available2017-05-08T23:49:39Z
dc.date.copyrightSeptember, 1996
dc.date.issued1996
dc.identifier.issn0022-0434
dc.identifier.otherJDSMAA-26227#499_1.pdf
dc.identifier.urihttp://yetl.yabesh.ir/yetl/handle/yetl/116666
dc.description.abstractThe mode shapes, frequencies, and modal mass and stiffness coefficients of multibody systems such as tracked vehicles can be determined using experimental identification techniques. In multibody simulations, however, knowledge of the modal parameters of the individual components is required, and consequently, a procedure for extracting the component modes from the mode shapes of the assembled system must be used if experimental modal analysis techniques are to be used with general purpose multibody computer codes. In this investigation, modal parameters (modal mass, modal stiffness, modal damping, and mode shapes), which are determined experimentally, are employed to simulate the nonlinear dynamic behavior of a multibody tracked vehicle which consists of interconnected rigid and flexible components. The equations of motion of the vehicle are formulated in terms of a set of modal and reference generalized coordinates, and the theoretical basis for extracting the component modal parameters of the chassis from the modal parameters of the assembled vehicle is described. In this investigation, the track of the vehicle is modeled as a closed kinematic chain that consists of rigid links connected by revolute joints, and the effect of the chassis flexibility on the motion singularities of the track is examined numerically. These singularities which are encountered as the result of the change in the track configuration are avoided by using a deformable secondary joint instead of using the loop-closure equations.
dc.publisherThe American Society of Mechanical Engineers (ASME)
dc.titleDynamics of Multibody Tracked Vehicles Using Experimentally Identified Modal Parameters
dc.typeJournal Paper
dc.journal.volume118
dc.journal.issue3
dc.journal.titleJournal of Dynamic Systems, Measurement, and Control
dc.identifier.doi10.1115/1.2801173
dc.journal.fristpage499
dc.journal.lastpage507
dc.identifier.eissn1528-9028
dc.keywordsDynamics (Mechanics)
dc.keywordsTracked vehicles
dc.keywordsShapes
dc.keywordsVehicles
dc.keywordsStiffness
dc.keywordsMultibody systems
dc.keywordsClosed kinematic chains
dc.keywordsComputers
dc.keywordsEquations
dc.keywordsFrequency
dc.keywordsPlasticity
dc.keywordsMotion
dc.keywordsEquations of motion
dc.keywordsDamping AND Engineering simulation
dc.treeJournal of Dynamic Systems, Measurement, and Control:;1996:;volume( 118 ):;issue: 003
dc.contenttypeFulltext


Files in this item

Thumbnail

This item appears in the following Collection(s)

Show simple item record