Show simple item record

dc.contributor.authorYuedong Chen
dc.contributor.authorR. Du
dc.date.accessioned2017-05-08T23:49:37Z
dc.date.available2017-05-08T23:49:37Z
dc.date.copyrightSeptember, 1996
dc.date.issued1996
dc.identifier.issn0022-0434
dc.identifier.otherJDSMAA-26227#635_1.pdf
dc.identifier.urihttp://yetl.yabesh.ir/yetl/handle/yetl/116648
dc.description.abstractArtificial Neural Network (ANN) has been widely used for engineering monitoring and diagnosis. However, there are still several important problems unsolved and one of them is the architecture design of the ANN (namely, choosing the number of nodes in the hidden layer). In this technical brief, a new method of ANN architecture is introduced based on the idea that an ANN represents a mapping of training samples. Hence, the best ANN should represent the mapping that is most similar to the training samples. The method is tested using three practical engineering monitoring and diagnosis examples, including tool condition monitoring in turning, cutting condition monitoring in tapping, and metallographic condition monitoring in welding. It is demonstrated that the proposed method can improve the monitoring and diagnosis by approximately 3 percent.
dc.publisherThe American Society of Mechanical Engineers (ASME)
dc.titleArtificial Neural Network Architecture Design Using Similarity Measure With Applications in Engineering Monitoring and Diagnosis
dc.typeJournal Paper
dc.journal.volume118
dc.journal.issue3
dc.journal.titleJournal of Dynamic Systems, Measurement, and Control
dc.identifier.doi10.1115/1.2801194
dc.journal.fristpage635
dc.journal.lastpage639
dc.identifier.eissn1528-9028
dc.keywordsDesign
dc.keywordsArtificial neural networks
dc.keywordsPatient diagnosis
dc.keywordsCondition monitoring
dc.keywordsCutting AND Welding
dc.treeJournal of Dynamic Systems, Measurement, and Control:;1996:;volume( 118 ):;issue: 003
dc.contenttypeFulltext


Files in this item

Thumbnail

This item appears in the following Collection(s)

Show simple item record