• Login
    View Item 
    •   DSpace Home
    • ASME
    • Journal of Pressure Vessel Technology
    • View Item
    •   DSpace Home
    • ASME
    • Journal of Pressure Vessel Technology
    • View Item
    JavaScript is disabled for your browser. Some features of this site may not work without it.

    Effect of Reinforcement on the Strength of Junctions Between Cylindrical and Conical Shells

    Thumbnail
    View/Open
    JPVTAS-28359#135_1.pdf (639.6Kb)
    Date
    1995
    Author
    A. Kalnins
    D. P. Updike
    Metadata
    Show full item record
    Abstract
    Two failure modes are addressed for cylinder-cone junctions under internal or external pressure: axisymmetric yielding and low-cycle fatigue. If the junction fails to meet the failure criterion of any one of the two modes, then it must be strengthened by reinforcement. It is shown in the paper that the degree to which a junction is strengthened depends on the distribution of the reinforcement. A placement of reinforcement on the cylinder alone, leaving the actual connection between the cylinder and cone unreinforced, adds strength with regard to axisymmetric yielding, but may not strengthen the junction sufficiently with regard to low-cycle fatigue. This means that the junction may appear reinforced, but is not strengthened. It is pointed out that the design rules of Section VIII, Div. 1 of the ASME B & PV Code (1992) set the need for reinforcement according to the failure criterion of low-cycle fatigue, while the distribution of the reinforcement is guided by the criterion of axisymmetric yielding. There is no assurance that the reinforced junction will meet the failure criterion of low-cycle fatigue. This means that the safety margin on the number of allowed cycles is less than that which is expected and that the junction may be unfit for cyclic service. It is also shown in the paper that a reinforcement distribution that requires minimum thicknesses for sections of both the cylinder and cone near the junction can satisfy criteria for both failure modes. This approach is already used in Code Case 2150 of Section VIII, Div. 1, for half-apex cone angles from 30 to 60 deg, and required in Div. 2 for cone angles from 0 to 30 deg. Its extension to angles from 0 to 60 deg for both internal and external pressure is recommended.
    URI
    http://yetl.yabesh.ir/yetl/handle/yetl/115862
    Collections
    • Journal of Pressure Vessel Technology

    DSpace software copyright © 2002-2015  DuraSpace
    Contact Us | Send Feedback
    Theme by 
    @mire NV
     

     

    Browse

    All of DSpaceCommunities & CollectionsBy Issue DateAuthorsTitlesSubjectsThis CollectionBy Issue DateAuthorsTitlesSubjects

    My Account

    LoginRegister

    Statistics

    View Usage Statistics

    DSpace software copyright © 2002-2015  DuraSpace
    Contact Us | Send Feedback
    Theme by 
    @mire NV