Show simple item record

dc.contributor.authorS. M. Tipton
dc.contributor.authorK. A. Hickey
dc.contributor.authorJ. R. Sorem
dc.contributor.authorM. S. Rawson
dc.date.accessioned2017-05-08T23:48:08Z
dc.date.available2017-05-08T23:48:08Z
dc.date.copyrightNovember, 1995
dc.date.issued1995
dc.identifier.issn0094-9930
dc.identifier.otherJPVTAS-28363#404_1.pdf
dc.identifier.urihttp://yetl.yabesh.ir/yetl/handle/yetl/115840
dc.description.abstractA thick-walled cylindrical specimen containing an external circumferential groove was subjected to external pressure. To investigate the maximum pressure sustainable by the reduced wall thickness, strain gage measurements were taken during external pressurization tests. For comparison to experimental results, an elastic-plastic notch stress-strain analysis was conducted based on Neuber’s rule. The analysis utilized multiaxial elastic finite element results along with elastic-plastic tensile test data for the cylinder material. Based on experimental observations, it was necessary to supplement the approach with an additional relation between elastic and elastic-plastic multiaxial strains for the axisymmetric geometry under investigation. Assuming an invariant hoop to radial strain ratio rather than an invariant hoop to axial strain ratio provided better agreement with experimental results. It is demonstrated that the boundary conditions used to model the specimen had a substantial effect on the finite element results, even though the boundary was somewhat removed from the region of concentrated stress. Biaxial strain measurements are presented versus pressure over the elastic and into the plastic regime, and deformation plasticity theory was used to compute stress and radial strain components corresponding to measured strains. It is demonstrated that in order to apply a multiaxial Neuber’s rule to accurately estimate the elastic-plastic stress-strain response (using elastic stress concentration information and elastic-plastic material data), it is necessary to utilize an experimental observation that the ratio of the hoop to radial strain remains invariant from the elastic to the elastic-plastic regime. This differs from published assumptions about invariant hoop-to-axial strain ratios based on analysis of circumferentially grooved solid shafts. The predictions are accurate for moderate plastic strains, but correlation breaks down for bulk plastic deformation.
dc.publisherThe American Society of Mechanical Engineers (ASME)
dc.titleMultiaxial Stress Concentration in an Externally Pressurized Cylinder With an External Circumferential Groove
dc.typeJournal Paper
dc.journal.volume117
dc.journal.issue4
dc.journal.titleJournal of Pressure Vessel Technology
dc.identifier.doi10.1115/1.2842144
dc.journal.fristpage404
dc.journal.lastpage409
dc.identifier.eissn1528-8978
dc.keywordsStress concentration
dc.keywordsCylinders
dc.keywordsStress
dc.keywordsFinite element analysis
dc.keywordsPressure
dc.keywordsDeformation
dc.keywordsMeasurement
dc.keywordsPlasticity
dc.keywordsSustainability
dc.keywordsBoundary-value problems
dc.keywordsExternal pressure
dc.keywordsGeometry
dc.keywordsStrain gages
dc.keywordsStrain measurement AND Wall thickness
dc.treeJournal of Pressure Vessel Technology:;1995:;volume( 117 ):;issue: 004
dc.contenttypeFulltext


Files in this item

Thumbnail

This item appears in the following Collection(s)

Show simple item record