Show simple item record

dc.contributor.authorM. Murata
dc.contributor.authorM. B. Utzinger
dc.contributor.authorD.-H. Chen
dc.contributor.authorH. Nisitani
dc.date.accessioned2017-05-08T23:48:07Z
dc.date.available2017-05-08T23:48:07Z
dc.date.copyrightNovember, 1995
dc.date.issued1995
dc.identifier.issn0094-9930
dc.identifier.otherJPVTAS-28363#293_1.pdf
dc.identifier.urihttp://yetl.yabesh.ir/yetl/handle/yetl/115819
dc.description.abstractFor rectangular cross-sectional ring headers, the authors’ theoretical stress analysis is presented to agree with actual stresses by measurement with strain gages. Therefore, this analytical method is applicable for similar rectangular cross-sectional ring headers. When the aspect ratio (length of two cylinders/radius difference between two cylinders) is more than three, moments originating at the end of finite long cylinders and tangential stresses on the half-length of both cylinders are almost the same as values from infinitely long cylinders. Regarding the welds between flat cover plates and cylinders, cover plate designs can be remarkably thinner by changing the weld shape, that is, by using T-joint weld with a single-bevel groove, than compared to Type (i) in PG-31 of ASME Code.
dc.publisherThe American Society of Mechanical Engineers (ASME)
dc.titleStress Analysis on Rectangular Cross-Sectional Ring Headers
dc.typeJournal Paper
dc.journal.volume117
dc.journal.issue4
dc.journal.titleJournal of Pressure Vessel Technology
dc.identifier.doi10.1115/1.2842126
dc.journal.fristpage293
dc.journal.lastpage297
dc.identifier.eissn1528-8978
dc.keywordsStress analysis (Engineering)
dc.keywordsCylinders
dc.keywordsStress
dc.keywordsWelded joints
dc.keywordsPlates (structures)
dc.keywordsShapes
dc.keywordsStrain gages AND ASME Standards
dc.treeJournal of Pressure Vessel Technology:;1995:;volume( 117 ):;issue: 004
dc.contenttypeFulltext


Files in this item

Thumbnail

This item appears in the following Collection(s)

Show simple item record