Show simple item record

dc.contributor.authorAkihisa Kikuchi
dc.contributor.authorEvelitsa Higuerey
dc.contributor.authorJohn Coulter
dc.date.accessioned2017-05-08T23:47:23Z
dc.date.available2017-05-08T23:47:23Z
dc.date.copyrightJanuary, 1995
dc.date.issued1995
dc.identifier.issn0094-4289
dc.identifier.otherJEMTA8-26969#86_1.pdf
dc.identifier.urihttp://yetl.yabesh.ir/yetl/handle/yetl/115432
dc.description.abstractThe present investigation focused on the need for sensing subsystems for the monitoring of resin flow dynamics during molding processes. Such subsystems, when combined with process parameter control, will produce intelligent manufacturing systems that could significantly improve manufacturing capabilities. A concise review of potential resin flow monitoring methodologies is included, and a detailed analysis of one particular sensing concept originally investigated at the U. S. Army Materials Technology Laboratory is presented. The concept is based on embedded electronic sensors, and during the present study a resin front monitoring system based on a modified version of this concept was developed. Electrically conductive wires were embedded orthogonally in a nonintersecting manner within mold cavities. Subsequent resin flow was sensed by monitoring the electrical characteristics of circuits which resulted during processing. A novel modification of circuitry was included to allow for the monitoring at multiple locations with a single electronic circuit. The net result of this modification was an improved response time of the overall sensing subsystem. The concept was verified experimentally through the performance of both one-dimensional (TD) and two-dimensional (2-D) experiments. The resin system utilized consisted of a mixture of epoxy resin (EPON 826) and a curing agent (MHHPA). The sensed flow front progression information was validated through controlled injection rate experimentation and flow visualization results obtained with transparent molds. It was concluded that the resin flow sensing subsystem could be applied to relatively slow molding processes. Positive and negative aspects related to the applicability of the sensing method to actual manufacturing processes are discussed.
dc.publisherThe American Society of Mechanical Engineers (ASME)
dc.titleAn Experimental Investigation of Resin Flow Sensing During Molding Processes
dc.typeJournal Paper
dc.journal.volume117
dc.journal.issue1
dc.journal.titleJournal of Engineering Materials and Technology
dc.identifier.doi10.1115/1.2804376
dc.journal.fristpage86
dc.journal.lastpage93
dc.identifier.eissn1528-8889
dc.keywordsFlow (Dynamics)
dc.keywordsMolding
dc.keywordsResins
dc.keywordsManufacturing
dc.keywordsCircuits
dc.keywordsCuring
dc.keywordsManufacturing systems
dc.keywordsMaterials technology
dc.keywordsMixtures
dc.keywordsMonitoring systems
dc.keywordsWire
dc.keywordsEpoxy resins
dc.keywordsSensors
dc.keywordsTransparency
dc.keywordsArmy
dc.keywordsFlow visualization AND Cavities
dc.treeJournal of Engineering Materials and Technology:;1995:;volume( 117 ):;issue: 001
dc.contenttypeFulltext


Files in this item

Thumbnail

This item appears in the following Collection(s)

Show simple item record