Show simple item record

dc.contributor.authorP. Gilotte
dc.contributor.authorR. Hamar
dc.contributor.authorL. V. Huynh
dc.contributor.authorJ. Etay
dc.date.accessioned2017-05-08T23:47:23Z
dc.date.available2017-05-08T23:47:23Z
dc.date.copyrightJanuary, 1995
dc.date.issued1995
dc.identifier.issn0094-4289
dc.identifier.otherJEMTA8-26969#82_1.pdf
dc.identifier.urihttp://yetl.yabesh.ir/yetl/handle/yetl/115431
dc.description.abstractThis paper deals with the filling steps in the mold casting process. Attention is focused on the shapes of the free surfaces of the filling jet. The shapes are determined through an experimental device and a numerical code. Although the assumptions for the calculations are strong, the obtained results agree well with the experimental results.
dc.publisherThe American Society of Mechanical Engineers (ASME)
dc.titleShape of the Free Surfaces of the Jet in Mold Casting Numerical Modeling and Experiments
dc.typeJournal Paper
dc.journal.volume117
dc.journal.issue1
dc.journal.titleJournal of Engineering Materials and Technology
dc.identifier.doi10.1115/1.2804375
dc.journal.fristpage82
dc.journal.lastpage85
dc.identifier.eissn1528-8889
dc.keywordsCasting
dc.keywordsComputer simulation AND Shapes
dc.treeJournal of Engineering Materials and Technology:;1995:;volume( 117 ):;issue: 001
dc.contenttypeFulltext


Files in this item

Thumbnail

This item appears in the following Collection(s)

Show simple item record