Show simple item record

dc.contributor.authorByung Sun Kim
dc.contributor.authorTerry F. Lehnhoff
dc.date.accessioned2017-05-08T23:47:22Z
dc.date.available2017-05-08T23:47:22Z
dc.date.copyrightApril, 1995
dc.date.issued1995
dc.identifier.issn0094-4289
dc.identifier.otherJEMTA8-26970#235_1.pdf
dc.identifier.urihttp://yetl.yabesh.ir/yetl/handle/yetl/115418
dc.description.abstractAn aluminum mold was designed for fabrication of research quality composite tubes on a hot press (miniclave). This mold allows the pressure to be applied uniformly to the inner surface of a composite (prepreg tape) tube while a constant vacuum is also applied independently to the composite throughout the course of fabrication. With proper placement of stoppers and spacers inside the mold, various types of high quality unidirectional composites with fibers oriented either in the zero or 90 degree directions, respectively, were fabricated on a hot press. The mold design had less resin loss throughout fabrication compared to a conventional tubular mold. Physical and material tests have characterized the superior qualities of the resulting composite tubes.
dc.publisherThe American Society of Mechanical Engineers (ASME)
dc.titlePolymeric Composite Tube Fabrication
dc.typeJournal Paper
dc.journal.volume117
dc.journal.issue2
dc.journal.titleJournal of Engineering Materials and Technology
dc.identifier.doi10.1115/1.2804535
dc.journal.fristpage235
dc.journal.lastpage237
dc.identifier.eissn1528-8889
dc.keywordsManufacturing
dc.keywordsPolymer composites
dc.keywordsComposite materials
dc.keywordsPresses
dc.keywordsResins
dc.keywordsDesign
dc.keywordsFibers
dc.keywordsVacuum
dc.keywordsPressure AND Aluminum
dc.treeJournal of Engineering Materials and Technology:;1995:;volume( 117 ):;issue: 002
dc.contenttypeFulltext


Files in this item

Thumbnail

This item appears in the following Collection(s)

Show simple item record