Show simple item record

dc.contributor.authorJ. G. Lenard
dc.contributor.authorM. E. Davies
dc.date.accessioned2017-05-08T23:47:22Z
dc.date.available2017-05-08T23:47:22Z
dc.date.copyrightApril, 1995
dc.date.issued1995
dc.identifier.issn0094-4289
dc.identifier.otherJEMTA8-26970#220_1.pdf
dc.identifier.urihttp://yetl.yabesh.ir/yetl/handle/yetl/115416
dc.description.abstractModern hot metalforming operations require a predictive-adaptive control program in which the predictive component precalculates the necessary parameters—such as temperatures and loads—and the adaptive component sets up, monitors and adjusts the forming equipment. One of the needs of a predictive model of the process is for an understanding of the boundary conditions at the surface of contact. For high temperature operations, one of these conditions is described by the heat transfer coefficient, relating the heat flux and the difference of the temperatures of the contacting surfaces, at the die-workpiece interface. The surface temperatures are, of course, dependent on the distribution of the temperatures within the body of the dies. The determination of these distributions is the topic of the present project. Thermocouples embedded in a cold/hot die set as well as thermocouples placed on the surface of contact are used to monitor the temperature fields, within the body as well as on the surfaces, for various interface pressures, initial temperatures and materials. The results indicate that direct measurements of the temperatures of the contacting surfaces is very difficult and may lead to significant errors. It is recommended that a mathematical model, which uses the measured internal temperatures as initial conditions, should be employed to calculate the contact surface temperatures.
dc.publisherThe American Society of Mechanical Engineers (ASME)
dc.titleThe Distribution of Temperatures in a Hot/Cold Die Set: The Effect of the Pressure, Temperature, and Material
dc.typeJournal Paper
dc.journal.volume117
dc.journal.issue2
dc.journal.titleJournal of Engineering Materials and Technology
dc.identifier.doi10.1115/1.2804533
dc.journal.fristpage220
dc.journal.lastpage227
dc.identifier.eissn1528-8889
dc.keywordsPressure
dc.keywordsTemperature
dc.keywordsThermocouples
dc.keywordsHeat flux
dc.keywordsHeat transfer coefficients
dc.keywordsHigh temperature
dc.keywordsMeasurement
dc.keywordsStress
dc.keywordsForming equipment (Packaging)
dc.keywordsBoundary-value problems AND Errors
dc.treeJournal of Engineering Materials and Technology:;1995:;volume( 117 ):;issue: 002
dc.contenttypeFulltext


Files in this item

Thumbnail

This item appears in the following Collection(s)

Show simple item record