Show simple item record

dc.contributor.authorP. Hancock
dc.contributor.authorJ. P. Chubb
dc.contributor.authorJ. Spurrier
dc.date.accessioned2017-05-08T23:47:21Z
dc.date.available2017-05-08T23:47:21Z
dc.date.copyrightApril, 1995
dc.date.issued1995
dc.identifier.issn0094-4289
dc.identifier.otherJEMTA8-26970#209_1.pdf
dc.identifier.urihttp://yetl.yabesh.ir/yetl/handle/yetl/115414
dc.description.abstractCTOD, Charpy, and wide plate results from welded constructional steels are collected from nine companies. The resulting large data bank is analyzed statistically to identify general trends in properties of welded constructional steels. The present paper uses the data bank to review the effect of post-weld heat treatment (PWHT) on the fracture behavior of the weldments. Analysis shows the beneficial effect of PWHT at all thicknesses. The results are subsequently used to question the normal practice of post-weld heat treating weldments of 50 mm and above in thickness while leaving weldments of below 50 mm thick in the as welded condition. It is suggested that there is no significant difference in as welded fracture properties in weldments until thicknesses are well in excess of 100 mm.
dc.publisherThe American Society of Mechanical Engineers (ASME)
dc.titleA New Perspective on the Influence of Thickness and Post-Weld Heat Treatment for Large Scale Welded Joints
dc.typeJournal Paper
dc.journal.volume117
dc.journal.issue2
dc.journal.titleJournal of Engineering Materials and Technology
dc.identifier.doi10.1115/1.2804531
dc.journal.fristpage209
dc.journal.lastpage214
dc.identifier.eissn1528-8889
dc.keywordsHeat treating (Metalworking)
dc.keywordsWelded joints
dc.keywordsThickness
dc.keywordsFracture (Process)
dc.keywordsSteel AND Heat
dc.treeJournal of Engineering Materials and Technology:;1995:;volume( 117 ):;issue: 002
dc.contenttypeFulltext


Files in this item

Thumbnail

This item appears in the following Collection(s)

Show simple item record