Show simple item record

dc.contributor.authorFuh-Kuo Chen
dc.date.accessioned2017-05-08T23:47:20Z
dc.date.available2017-05-08T23:47:20Z
dc.date.copyrightJuly, 1995
dc.date.issued1995
dc.identifier.issn0094-4289
dc.identifier.otherJEMTA8-26972#269_1.pdf
dc.identifier.urihttp://yetl.yabesh.ir/yetl/handle/yetl/115391
dc.description.abstractThe shear properties of different simple-shear sheet specimens were investigated using the elastic-plastic finite element method. Tension loaded specimens with a shear zone formed at the center area between two transverse slots were adopted to analyze the shear properties of sheet metals under uniaxial tension. Specimens prepared by single material as well as by bonding two different strength materials together were both studied. Since the shear zone could not be kept free from bending stress during loading, the pure shear deformation was not possibly obtained. However, by varying the shape and the location of the slots, an optimum geometry of the shear zone which yields a nearly pure shear deformation in the plastic range was determined through the finite element analysis. The results also revealed when the shear zone was formed by a low strength material which was bonded on each side with a higher strength material, a nearly pure shear deformation could be obtained even in the elastic range.
dc.publisherThe American Society of Mechanical Engineers (ASME)
dc.titleDeformation Analysis of Simple-Shear Sheet Specimens
dc.typeJournal Paper
dc.journal.volume117
dc.journal.issue3
dc.journal.titleJournal of Engineering Materials and Technology
dc.identifier.doi10.1115/1.2804539
dc.journal.fristpage269
dc.journal.lastpage277
dc.identifier.eissn1528-8889
dc.keywordsDeformation AND Shear (Mechanics)
dc.treeJournal of Engineering Materials and Technology:;1995:;volume( 117 ):;issue: 003
dc.contenttypeFulltext


Files in this item

Thumbnail

This item appears in the following Collection(s)

Show simple item record