Show simple item record

dc.contributor.authorJ. Wu
dc.contributor.authorH. C. Juvkam-Wold
dc.date.accessioned2017-05-08T23:46:58Z
dc.date.available2017-05-08T23:46:58Z
dc.date.copyrightSeptember, 1995
dc.date.issued1995
dc.identifier.issn0195-0738
dc.identifier.otherJERTD2-26461#214_1.pdf
dc.identifier.urihttp://yetl.yabesh.ir/yetl/handle/yetl/115204
dc.description.abstractThis paper studies tubular buckling in curved wellbores (such as the build section of horizontal wells) and its effect on tubular “lockup” in horizontal or extended-reach wells. New buckling load equations are derived to properly predict tubular sinusoidal and helical buckling in such wellbores. The results show that the buckling loads to initiate sinusoidal and helical buckling of tubulars in curved wellbores are usually much larger than those in straight wellbores. This is because the curved wellbore tends to hold the axially compressed tubular against the outer-curve side of the wellbore. The tubular becomes less easy to buckle until higher axial compressive loads are applied. Less tubular lockup risk is then predicted for tubulars in horizontal or extended-reach wells by using the new buckling load equations. The new buckling loads in curved wellbores agree with those in straight wellbores when wellbore curvature approaches zero. Small-scale laboratory experiments also confirmed these theoretically derived buckling loads.
dc.publisherThe American Society of Mechanical Engineers (ASME)
dc.titleThe Effect of Wellbore Curvature on Tubular Buckling and Lockup
dc.typeJournal Paper
dc.journal.volume117
dc.journal.issue3
dc.journal.titleJournal of Energy Resources Technology
dc.identifier.doi10.1115/1.2835343
dc.journal.fristpage214
dc.journal.lastpage218
dc.identifier.eissn1528-8994
dc.keywordsBuckling
dc.treeJournal of Energy Resources Technology:;1995:;volume( 117 ):;issue: 003
dc.contenttypeFulltext


Files in this item

Thumbnail

This item appears in the following Collection(s)

Show simple item record