Show simple item record

dc.contributor.authorJ. A. Ackermann
dc.contributor.authorT. J. Kozik
dc.date.accessioned2017-05-08T23:46:57Z
dc.date.available2017-05-08T23:46:57Z
dc.date.copyrightDecember, 1995
dc.date.issued1995
dc.identifier.issn0195-0738
dc.identifier.otherJERTD2-26462#285_1.pdf
dc.identifier.urihttp://yetl.yabesh.ir/yetl/handle/yetl/115186
dc.description.abstractAn analytical method of examining the stress field near the edge of a simply supported, laminated beam was developed in Part I of this paper. The result was a system of second-order, ordinary, linear, nonhomogeneous differential equations. A numerical and analytical technique for solving these equations is presented in this paper. The method is a versatile stress analysis procedure which can accommodate any combination of material lay-up and can simulate any prescribed distribution of normal load on the upper and lower surfaces. The reactions at the ends of the beam may be distributed over the surface edges in a fashion most accurately characterizing the physical supports. An all-steel lay-up is examined as a basis for comparison with Bernoulli-Euler and Timoshenko theory; and a two-layered steel/aluminum beam is examined to simply demonstrate the method’s capability of determining the interlaminar transverse shear and normal stresses.
dc.publisherThe American Society of Mechanical Engineers (ASME)
dc.titleEnd Effects in Laminated Anisotropic Beams—Part II
dc.typeJournal Paper
dc.journal.volume117
dc.journal.issue4
dc.journal.titleJournal of Energy Resources Technology
dc.identifier.doi10.1115/1.2835425
dc.journal.fristpage285
dc.journal.lastpage289
dc.identifier.eissn1528-8994
dc.keywordsSteel
dc.keywordsStress
dc.keywordsShear (Mechanics)
dc.keywordsStress analysis (Engineering)
dc.keywordsDifferential equations AND Equations
dc.treeJournal of Energy Resources Technology:;1995:;volume( 117 ):;issue: 004
dc.contenttypeFulltext


Files in this item

Thumbnail

This item appears in the following Collection(s)

Show simple item record