Show simple item record

dc.contributor.authorF. Veniali
dc.contributor.authorA. Di Ilio
dc.contributor.authorV. Tagliaferri
dc.date.accessioned2017-05-08T23:46:57Z
dc.date.available2017-05-08T23:46:57Z
dc.date.copyrightDecember, 1995
dc.date.issued1995
dc.identifier.issn0195-0738
dc.identifier.otherJERTD2-26462#271_1.pdf
dc.identifier.urihttp://yetl.yabesh.ir/yetl/handle/yetl/115184
dc.description.abstractMajor drilling characteristics of Aramid fiber-reinforced plastics are experimentally investigated. The chip appears highly deformed and tends to smear on the tool. Forces and, mainly, torque are more influenced by the tool diameter than by the feed rate and cutting speed. On the contrary, the specific cutting energy strongly depends upon the feed rate due to size effects of the tool tip. The damage in the work, i.e., delamination at entry and exit side, can be controlled by taking into account the relationships between machining parameters and forces and torque. Generally, the tool fails by gross brittle failure at the periphery rather than by generalized land wear.
dc.publisherThe American Society of Mechanical Engineers (ASME)
dc.titleAn Experimental Study of the Drilling of Aramid Composites
dc.typeJournal Paper
dc.journal.volume117
dc.journal.issue4
dc.journal.titleJournal of Energy Resources Technology
dc.identifier.doi10.1115/1.2835423
dc.journal.fristpage271
dc.journal.lastpage278
dc.identifier.eissn1528-8994
dc.keywordsComposite materials AND Drilling
dc.treeJournal of Energy Resources Technology:;1995:;volume( 117 ):;issue: 004
dc.contenttypeFulltext


Files in this item

Thumbnail

This item appears in the following Collection(s)

Show simple item record