Show simple item record

dc.contributor.authorKyongsu Yi
dc.contributor.authorKarl Hedrick
dc.date.accessioned2017-05-08T23:46:50Z
dc.date.available2017-05-08T23:46:50Z
dc.date.copyrightJune, 1995
dc.date.issued1995
dc.identifier.issn0022-0434
dc.identifier.otherJDSMAA-26215#175_1.pdf
dc.identifier.urihttp://yetl.yabesh.ir/yetl/handle/yetl/115094
dc.description.abstractThis paper deals with an observer-based nonlinear system parameter identification method utilizing repetitive excitation. Although methods for physical parameter identification of both linear and nonlinear systems are already available, they are not attractive from a practical point of view since the methods assume that all the system, x , and the system input are available. The proposed method is based on a “sliding observer” and a least-square method. A sufficient condition for the convergence of the parameter estimates is provided in the case of “Lipschitz” nonlinear second-order systems. The observer is used to estimate signals which are difficult or expensive to measure. Using the estimated states of the system with repetitive excitation, the parameter estimates are obtained. The observer based identification method has been tested on a half car simulation and used to identify the parameters of a half car suspension test rig. The estimates of nonlinear damping coefficients of a vehicle suspension, suspension stiffness, pitch moment inertia, equivalent sprung mass, and unsprung mass are obtained by the proposed method. Simulation and experimental results show that the identifier estimates the vehicle parameters accurately. The proposed identifier will be useful for parameter identification of actual vehicles since vehicle parameters can be identified only using vehicle excitation tests rather than component testing.
dc.publisherThe American Society of Mechanical Engineers (ASME)
dc.titleObserver-Based Identification of Nonlinear System Parameters
dc.typeJournal Paper
dc.journal.volume117
dc.journal.issue2
dc.journal.titleJournal of Dynamic Systems, Measurement, and Control
dc.identifier.doi10.1115/1.2835177
dc.journal.fristpage175
dc.journal.lastpage182
dc.identifier.eissn1528-9028
dc.keywordsNonlinear systems
dc.keywordsVehicles
dc.keywordsSimulation
dc.keywordsSuspension systems
dc.keywordsDamping
dc.keywordsTesting
dc.keywordsSignals
dc.keywordsStiffness AND Inertia (Mechanics)
dc.treeJournal of Dynamic Systems, Measurement, and Control:;1995:;volume( 117 ):;issue: 002
dc.contenttypeFulltext


Files in this item

Thumbnail

This item appears in the following Collection(s)

Show simple item record