Show simple item record

dc.contributor.authorD. P. Jones
dc.contributor.authorJ. L. Hechmer
dc.contributor.authorB. A. James
dc.contributor.authorR. G. Hoppe
dc.date.accessioned2017-05-08T23:45:20Z
dc.date.available2017-05-08T23:45:20Z
dc.date.copyrightAugust, 1994
dc.date.issued1994
dc.identifier.issn0094-9930
dc.identifier.otherJPVTAS-28354#317_1.pdf
dc.identifier.urihttp://yetl.yabesh.ir/yetl/handle/yetl/114248
dc.description.abstractA series of fatigue crack growth rate tests was conducted in order to study the effects of negative stress ratio upon the fatigue crack growth rate of low-alloy steel in air environment. The tests used four-point bend specimens in order to simulate linear stress distributions typical of many pressure vessel applications. This type of testing adds to the knowledge on negative stress ratio effects for low-alloy steels that in the past have been obtained from uniform tension-compression tests. Additionally, the applied bending stress range was varied from low values of applied stress to high values of applied stress over twice the yield strength. Load control was used for tests for which the stress range was less than twice the yield strength and deflection control was used for the higher stress range tests. The crack geometries involved were both short and long fatigue cracks started at notches and tight fatigue cracks for which crack closure could occur over the full crack face. The results are presented in terms of the stress intensity factor ratio R = K MIN /K MAX . The negative R -ratio test results were correlated to an equation of the form da/dN = C[ΔK/(A−R)]n where A , C , and n are curve-fitting parameters. It was found that the effects of negative R -ratio on the fatigue crack growth rates for even the high stress range tests could be bounded by correlating the foregoing equation to only positive R -ratio test results and extending the resulting equation into the negative R -ratio regime.
dc.publisherThe American Society of Mechanical Engineers (ASME)
dc.titleAn Experimental Study on the Effects of Compressive Stress on the Fatigue Crack Growth of Low-Alloy Steel
dc.typeJournal Paper
dc.journal.volume116
dc.journal.issue3
dc.journal.titleJournal of Pressure Vessel Technology
dc.identifier.doi10.1115/1.2929595
dc.journal.fristpage317
dc.journal.lastpage323
dc.identifier.eissn1528-8978
dc.keywordsAlloys
dc.keywordsSteel
dc.keywordsCompressive stress
dc.keywordsFatigue cracks
dc.keywordsStress
dc.keywordsFracture (Materials)
dc.keywordsEquations
dc.keywordsYield strength
dc.keywordsFittings
dc.keywordsTension
dc.keywordsBending (Stress)
dc.keywordsTesting
dc.keywordsCompression
dc.keywordsDeflection AND Pressure vessels
dc.treeJournal of Pressure Vessel Technology:;1994:;volume( 116 ):;issue: 003
dc.contenttypeFulltext


Files in this item

Thumbnail

This item appears in the following Collection(s)

Show simple item record