Show simple item record

dc.contributor.authorL. S. Ong
dc.date.accessioned2017-05-08T23:45:19Z
dc.date.available2017-05-08T23:45:19Z
dc.date.copyrightAugust, 1994
dc.date.issued1994
dc.identifier.issn0094-9930
dc.identifier.otherJPVTAS-28354#274_1.pdf
dc.identifier.urihttp://yetl.yabesh.ir/yetl/handle/yetl/114239
dc.description.abstractPresence of initial shape imperfection causes additional bending stresses to be developed in a pressurized cylinder. Although the bending stress will initially increase with pressure, it will finally settle down to a certain value. This article derives the maximum bending stress associated with the geometric shape imperfection. It also discusses the implication of this additional bending stress on the design stress and allowable shape tolerance. Finally, it is concluded that a 1-percent diametral deviation, as commonly specified by most design codes, is adequate and sound for the internally pressurized cylinder.
dc.publisherThe American Society of Mechanical Engineers (ASME)
dc.titleAllowable Shape Deviation in a Pressurized Cylinder
dc.typeJournal Paper
dc.journal.volume116
dc.journal.issue3
dc.journal.titleJournal of Pressure Vessel Technology
dc.identifier.doi10.1115/1.2929587
dc.journal.fristpage274
dc.journal.lastpage277
dc.identifier.eissn1528-8978
dc.keywordsCylinders
dc.keywordsShapes
dc.keywordsBending (Stress)
dc.keywordsDesign
dc.keywordsPressure
dc.keywordsSound AND Stress
dc.treeJournal of Pressure Vessel Technology:;1994:;volume( 116 ):;issue: 003
dc.contenttypeFulltext


Files in this item

Thumbnail

This item appears in the following Collection(s)

Show simple item record