Show simple item record

dc.contributor.authorHong Lin
dc.contributor.authorHamid Nayeb-Hashemi
dc.contributor.authorCharles A. Berg
dc.date.accessioned2017-05-08T23:44:28Z
dc.date.available2017-05-08T23:44:28Z
dc.date.copyrightJanuary, 1994
dc.date.issued1994
dc.identifier.issn0094-4289
dc.identifier.otherJEMTA8-26961#27_1.pdf
dc.identifier.urihttp://yetl.yabesh.ir/yetl/handle/yetl/113720
dc.description.abstractTwo types of low cycle fatigue tests were conducted along two principal orthotropic directions of an orthotropic Al-6061-T6 plate in strain control at room temperature: (1) reference fatigue tests under three loading conditions: push-pull, torsion, and combined push-pull/torsion in-phase; (2) sequential fatigue tests in which different sequences of push-pull and torsion were performed. Fatigue cracking behavior was observed during all of the fatigue tests. Shear cracking dominated the damage of the material. Anisotropic constitutive relations of the material were used in the evaluation of several multiaxial fatigue damage models. The predictive capabilities of these models were assessed based on the results of reference fatigue tests. The damage accumulation behavior of the material was found to depend on the sequence of the loading mode. For the sequence of torsion then push-pull, the damage summation was greater than unity. However, for the sequence of push-pull then torsion, the damage accumulation was near unity as predicted by the linear damage rule. A nonlinear damage accumulation rule could represent the results of the sequential fatigue tests.
dc.publisherThe American Society of Mechanical Engineers (ASME)
dc.titleCumulative Damage Behavior of Anisotropic Al-6061-T6 as a Function of Axial-Torsional Loading Mode Sequence
dc.typeJournal Paper
dc.journal.volume116
dc.journal.issue1
dc.journal.titleJournal of Engineering Materials and Technology
dc.identifier.doi10.1115/1.2904252
dc.journal.fristpage27
dc.journal.lastpage34
dc.identifier.eissn1528-8889
dc.keywordsTemperature
dc.keywordsShear (Mechanics)
dc.keywordsTorsion
dc.keywordsConstitutive equations
dc.keywordsFracture (Process)
dc.keywordsFatigue cracks
dc.keywordsFatigue damage
dc.keywordsFatigue testing AND Low cycle fatigue
dc.treeJournal of Engineering Materials and Technology:;1994:;volume( 116 ):;issue: 001
dc.contenttypeFulltext


Files in this item

Thumbnail

This item appears in the following Collection(s)

Show simple item record