Show simple item record

dc.contributor.authorW. Cheng
dc.contributor.authorI. Finnie
dc.contributor.authorM. Gremaud
dc.contributor.authorM. B. Prime
dc.date.accessioned2017-05-08T23:44:27Z
dc.date.available2017-05-08T23:44:27Z
dc.date.copyrightJanuary, 1994
dc.date.issued1994
dc.identifier.issn0094-4289
dc.identifier.otherJEMTA8-26961#1_1.pdf
dc.identifier.urihttp://yetl.yabesh.ir/yetl/handle/yetl/113716
dc.description.abstractIn previous work it has been shown that near surface residual stresses may be deduced from surface strains produced by making a cut of progressively increasing depth. The process of electric discharge wire machining (EDWM), by providing very narrow cuts, greatly improves the ability of the method to resolve a stress gradient near the surface. However, the EDWM process may also introduce residual stresses. In the present work a model for estimating the influence of EDWM is presented, and a procedure for eliminating its effect on residual stress measurement is developed. Experimental results validate the theoretical approach.
dc.publisherThe American Society of Mechanical Engineers (ASME)
dc.titleMeasurement of Near Surface Residual Stresses Using Electric Discharge Wire Machining
dc.typeJournal Paper
dc.journal.volume116
dc.journal.issue1
dc.journal.titleJournal of Engineering Materials and Technology
dc.identifier.doi10.1115/1.2904251
dc.journal.fristpage1
dc.journal.lastpage7
dc.identifier.eissn1528-8889
dc.keywordsElectric discharge
dc.keywordsMachining
dc.keywordsWire
dc.keywordsResidual stresses
dc.keywordsStress AND Gradients
dc.treeJournal of Engineering Materials and Technology:;1994:;volume( 116 ):;issue: 001
dc.contenttypeFulltext


Files in this item

Thumbnail

This item appears in the following Collection(s)

Show simple item record