Show simple item record

dc.contributor.authorJ. Hu
dc.contributor.authorJ. H. Vogel
dc.date.accessioned2017-05-08T23:44:27Z
dc.date.available2017-05-08T23:44:27Z
dc.date.copyrightApril, 1994
dc.date.issued1994
dc.identifier.issn0094-4289
dc.identifier.otherJEMTA8-26963#244_1.pdf
dc.identifier.urihttp://yetl.yabesh.ir/yetl/handle/yetl/113714
dc.description.abstractA dynamic model of injection molding developed from physical considerations is used to select PID gains for pressure control during the packing phase of thermo-plastic injection molding. The relative importance of various aspects of the model and values for particular physical parameters were identified experimentally. The controller gains were chosen by pole-zero cancellation and root-locus methods, resulting in good control performance. Both open and closed-loop system responses were predicted and verified, with good overall agreement.
dc.publisherThe American Society of Mechanical Engineers (ASME)
dc.titleDynamic Modeling and Control of Packing Pressure in Injection Molding
dc.typeJournal Paper
dc.journal.volume116
dc.journal.issue2
dc.journal.titleJournal of Engineering Materials and Technology
dc.identifier.doi10.1115/1.2904280
dc.journal.fristpage244
dc.journal.lastpage249
dc.identifier.eissn1528-8889
dc.keywordsPressure
dc.keywordsPacking (Shipments)
dc.keywordsInjection molding
dc.keywordsDynamic modeling
dc.keywordsClosed loop systems
dc.keywordsPressure control
dc.keywordsDynamic models
dc.keywordsPoles (Building) AND Control equipment
dc.treeJournal of Engineering Materials and Technology:;1994:;volume( 116 ):;issue: 002
dc.contenttypeFulltext


Files in this item

Thumbnail

This item appears in the following Collection(s)

Show simple item record