Show simple item record

dc.contributor.authorR. C. Batra
dc.contributor.authorXiangtong Zhang
dc.date.accessioned2017-05-08T23:44:25Z
dc.date.available2017-05-08T23:44:25Z
dc.date.copyrightApril, 1994
dc.date.issued1994
dc.identifier.issn0094-4289
dc.identifier.otherJEMTA8-26963#155_1.pdf
dc.identifier.urihttp://yetl.yabesh.ir/yetl/handle/yetl/113699
dc.description.abstractMarchand and Duffy tested thin-walled steel tubes in a split Hopkinson torsion bar at a nominal strain-rate of approximately 1600/s and could not determine conclusively whether a shear band initiating at a point in the tube propagated around the circumference in one direction or in both directions. They estimated the speed of propagation to be 520 m/s in the former case and 260 m/s in the latter. Here we simulate their test numerically, and find that the shear band propagates in both directions around the circumference of the tube. When the tube is twisted at a nominal strain-rate of 5000/s, the band speed varies from 180 m/s at the site of the initiation to approximately 1000 m/s at the nearly diametrically opposite point. The band speed increases with an increase in the nominal strain-rate. The material defect is modeled by assuming that a small region near the center of the tubular surface is made of a material weaker than that of the rest of the tube.
dc.publisherThe American Society of Mechanical Engineers (ASME)
dc.titleOn the Propagation of a Shear Band in a Steel Tube
dc.typeJournal Paper
dc.journal.volume116
dc.journal.issue2
dc.journal.titleJournal of Engineering Materials and Technology
dc.identifier.doi10.1115/1.2904266
dc.journal.fristpage155
dc.journal.lastpage161
dc.identifier.eissn1528-8889
dc.keywordsSteel
dc.keywordsShear (Mechanics) AND Torsion
dc.treeJournal of Engineering Materials and Technology:;1994:;volume( 116 ):;issue: 002
dc.contenttypeFulltext


Files in this item

Thumbnail

This item appears in the following Collection(s)

Show simple item record