Show simple item record

dc.contributor.authorP. R. Cetlin
dc.contributor.authorA. P. Silva
dc.date.accessioned2017-05-08T23:44:21Z
dc.date.available2017-05-08T23:44:21Z
dc.date.copyrightOctober, 1994
dc.date.issued1994
dc.identifier.issn0094-4289
dc.identifier.otherJEMTA8-26967#574_1.pdf
dc.identifier.urihttp://yetl.yabesh.ir/yetl/handle/yetl/113663
dc.description.abstractThe experimental drawing of SAE 1008 steel bars was performed for different reductions in area (r) and die semi-angles (α). The redundant deformation factor (φ) was evaluated for each case using two techniques: microhardness profiles and stress-strain curves superposition. The experimental values of φ obtained by the two techniques were not in agreement.
dc.publisherThe American Society of Mechanical Engineers (ASME)
dc.titleA Comparison of Redundant Deformation Factors in the Drawing of Round Section Bars
dc.typeJournal Paper
dc.journal.volume116
dc.journal.issue4
dc.journal.titleJournal of Engineering Materials and Technology
dc.identifier.doi10.1115/1.2904331
dc.journal.fristpage574
dc.journal.lastpage575
dc.identifier.eissn1528-8889
dc.keywordsDeformation
dc.keywordsSteel
dc.keywordsStress-strain curves AND Microhardness
dc.treeJournal of Engineering Materials and Technology:;1994:;volume( 116 ):;issue: 004
dc.contenttypeFulltext


Files in this item

Thumbnail

This item appears in the following Collection(s)

Show simple item record