| dc.contributor.author | W. Cheng | |
| dc.contributor.author | M. Gremaud | |
| dc.contributor.author | A. Rosselet | |
| dc.contributor.author | R. D. Streit | |
| dc.contributor.author | I. Finnie | |
| dc.date.accessioned | 2017-05-08T23:44:21Z | |
| dc.date.available | 2017-05-08T23:44:21Z | |
| dc.date.copyright | October, 1994 | |
| dc.date.issued | 1994 | |
| dc.identifier.issn | 0094-4289 | |
| dc.identifier.other | JEMTA8-26967#556_1.pdf | |
| dc.identifier.uri | http://yetl.yabesh.ir/yetl/handle/yetl/113660 | |
| dc.description.abstract | Residual stresses due to surface treatment are measured using the compliance method. The method makes use of the strains measured on the surface while a cut is extended progressively along a plane of interest. The experimental results for a shot peened specimen show good agreement with those obtained by the X-ray method. This experiment demonstrates that the compliance method is accurate and capable of measuring residual stresses which vary rapidly over a depth of less than 50 μm. Good general agreement with results by the X-ray method is also obtained for a laser treated specimen. Some advantages and disadvantages of the present method relative to hole-drilling, layer removal and X-ray methods are discussed. | |
| dc.publisher | The American Society of Mechanical Engineers (ASME) | |
| dc.title | The Compliance Method for Measurement of Near Surface Residual Stresses—Application and Validation for Surface Treatment by Laser and Shot-Peening | |
| dc.type | Journal Paper | |
| dc.journal.volume | 116 | |
| dc.journal.issue | 4 | |
| dc.journal.title | Journal of Engineering Materials and Technology | |
| dc.identifier.doi | 10.1115/1.2904328 | |
| dc.journal.fristpage | 556 | |
| dc.journal.lastpage | 560 | |
| dc.identifier.eissn | 1528-8889 | |
| dc.keywords | Lasers | |
| dc.keywords | Residual stresses | |
| dc.keywords | Shot peening | |
| dc.keywords | Surface finishing | |
| dc.keywords | X-rays AND Drilling | |
| dc.tree | Journal of Engineering Materials and Technology:;1994:;volume( 116 ):;issue: 004 | |
| dc.contenttype | Fulltext | |