Show simple item record

dc.contributor.authorVipin Kumar
dc.contributor.authorKarl A. Seeler
dc.contributor.authorMichael VanderWel
dc.contributor.authorJohn Weller
dc.date.accessioned2017-05-08T23:44:19Z
dc.date.available2017-05-08T23:44:19Z
dc.date.copyrightOctober, 1994
dc.date.issued1994
dc.identifier.issn0094-4289
dc.identifier.otherJEMTA8-26967#439_1.pdf
dc.identifier.urihttp://yetl.yabesh.ir/yetl/handle/yetl/113640
dc.description.abstractNovel polycarbonate (PC) foams with bubbles on the order of 10 μm and cell nucleation densities between 1 and 10 billion cells per cubic centimeter of foam have been produced using carbon dioxide as the blowing agent. The size and number of bubbles can be controlled to produce a wide range of foam densities. This paper presents the results of an experimental study of the tensile behavior of these unique microcellular foams. It was found that the tensile strength of microcellular PC foams is proportional to the foam density. The strength is less than that predicted by the rule of mixtures, suggesting that the microcellular structure is inefficient in carrying the tensile load. The saturation of PC by CO2 was found to reduce the tensile strength of the virgin material by approximately 20 percent. This showed that the sorption of a very high concentration of gas molecules by the polymer must be considered when characterizing and modelling the microcellular foam mechanical properties. The relative tensile modulus of microcellular foam was found to increase as the square of the foam’s relative density over the range of densities explored.
dc.publisherThe American Society of Mechanical Engineers (ASME)
dc.titleExperimental Characterization of the Tensile Behavior of Microcellular Polycarbonate Foams
dc.typeJournal Paper
dc.journal.volume116
dc.journal.issue4
dc.journal.titleJournal of Engineering Materials and Technology
dc.identifier.doi10.1115/1.2904310
dc.journal.fristpage439
dc.journal.lastpage445
dc.identifier.eissn1528-8889
dc.keywordsFoams (Chemistry)
dc.keywordsExperimental characterization
dc.keywordsDensity
dc.keywordsTensile strength
dc.keywordsBubbles
dc.keywordsNucleation (Physics)
dc.keywordsSorption
dc.keywordsMechanical properties
dc.keywordsModeling
dc.keywordsPolymers
dc.keywordsCarbon dioxide
dc.keywordsMixtures AND Stress
dc.treeJournal of Engineering Materials and Technology:;1994:;volume( 116 ):;issue: 004
dc.contenttypeFulltext


Files in this item

Thumbnail

This item appears in the following Collection(s)

Show simple item record