Show simple item record

dc.contributor.authorJ. Rasty
dc.contributor.authorW. Kolarik
dc.contributor.authorB. Chen
dc.date.accessioned2017-05-08T23:44:01Z
dc.date.available2017-05-08T23:44:01Z
dc.date.copyrightSeptember, 1994
dc.date.issued1994
dc.identifier.issn0195-0738
dc.identifier.otherJERTD2-26456#232_1.pdf
dc.identifier.urihttp://yetl.yabesh.ir/yetl/handle/yetl/113485
dc.description.abstractRecent emphasis of the Department of Defense (DOD) on the reliability and integrity of avionics has spurred a new wave of research on this subject. This paper presents the results of a parametric investigation conducted to study the effect of vibration direction, boundary conditions, stiffeners and/or point supports, lead type, lead height, and the layout of the components on the natural frequencies and stresses exerted on a typical printed circuit board (PCB) used in avionics. The “robust design” procedure was adopted using a series of computer-simulated experiments. A finite element software, EMRC-FEAP, was utilized to estimate the maximum von Mises stresses within the critical leads, while the statistical analysis system (SAS) software was employed to analyze the natural frequency responses of the system and the signal-to-noise ratio (SNR) of the stresses induced at critical leads.
dc.publisherThe American Society of Mechanical Engineers (ASME)
dc.titleDesigning Surface-Mounted Components for High Reliability
dc.typeJournal Paper
dc.journal.volume116
dc.journal.issue3
dc.journal.titleJournal of Energy Resources Technology
dc.identifier.doi10.1115/1.2906448
dc.journal.fristpage232
dc.journal.lastpage239
dc.identifier.eissn1528-8994
dc.keywordsReliability AND Design
dc.treeJournal of Energy Resources Technology:;1994:;volume( 116 ):;issue: 003
dc.contenttypeFulltext


Files in this item

Thumbnail

This item appears in the following Collection(s)

Show simple item record