Show simple item record

dc.contributor.authorJ. L. Stein
dc.contributor.authorJ. F. Tu
dc.date.accessioned2017-05-08T23:43:45Z
dc.date.available2017-05-08T23:43:45Z
dc.date.copyrightSeptember, 1994
dc.date.issued1994
dc.identifier.issn0022-0434
dc.identifier.otherJDSMAA-26207#372_1.pdf
dc.identifier.urihttp://yetl.yabesh.ir/yetl/handle/yetl/113338
dc.description.abstractCatastrophic and premature bearing failure caused by excessive thermally induced bearing preload is a major design problem for spindle bearings of high-speed machine tools. Due to a lack of a low cost and easy to maintain on-line preload measuring technique, the traditional solution is to limit the maximum spindle speed and the initial bearing preload. This solution is incompatible with the need to increase machining productivity, which requires increasing the spindle speed, and to increase product quality (surface finish, dimensional accuracy), which requires increasing (or at least not decreasing) the preload to keep the spindle system stiff. This paper proposes a dynamic mathematical model of the spindle system, which can be used as part of a model-based monitoring system for estimating the spindle bearing preload. The model is derived from physical laws of heat transfer and thermoelasticity and represents the transient preload behavior induced by uneven thermal expansions within a bearing. The state-space structure of the model provides for efficient sensor selection and easy conversion into a state observer for on-line preload estimation. The state variables defined in the model are the temperatures of the outer ring/housing, the rolling elements, and the inner ring, while the induced preload is an algebraic function of these states. The model, which is successfully validated for two typical configurations of high speed spindle assemblies, provides a tool for understanding the basic mechanics of induced preload as a function of initial preload, spindle speed, and housing cooling conditions. Most importantly, the model meets the requirements as the basis of a preload observer developed by the authors. While the observer is not presented in this paper, basic issues related to its development are discussed.
dc.publisherThe American Society of Mechanical Engineers (ASME)
dc.titleA State-Space Model for Monitoring Thermally Induced Preload in Anti-Friction Spindle Bearings of High-Speed Machine Tools
dc.typeJournal Paper
dc.journal.volume116
dc.journal.issue3
dc.journal.titleJournal of Dynamic Systems, Measurement, and Control
dc.identifier.doi10.1115/1.2899232
dc.journal.fristpage372
dc.journal.lastpage386
dc.identifier.eissn1528-9028
dc.keywordsFriction
dc.keywordsMachine tools
dc.keywordsSpindles (Textile machinery)
dc.keywordsBearings
dc.keywordsDesign
dc.keywordsFailure
dc.keywordsMonitoring systems
dc.keywordsThermoelasticity
dc.keywordsFinishes
dc.keywordsSensors
dc.keywordsProduct quality
dc.keywordsTemperature
dc.keywordsHeat transfer
dc.keywordsCooling AND Machining
dc.treeJournal of Dynamic Systems, Measurement, and Control:;1994:;volume( 116 ):;issue: 003
dc.contenttypeFulltext


Files in this item

Thumbnail

This item appears in the following Collection(s)

Show simple item record