Show simple item record

dc.contributor.authorT. Kobayashi
dc.contributor.authorM. Tateishi
dc.date.accessioned2017-05-08T23:42:27Z
dc.date.available2017-05-08T23:42:27Z
dc.date.copyrightFebruary, 1993
dc.date.issued1993
dc.identifier.issn0094-9930
dc.identifier.otherJPVTAS-28341#47_1.pdf
dc.identifier.urihttp://yetl.yabesh.ir/yetl/handle/yetl/112556
dc.description.abstractThin-wall, large-diameter piping for liquid metal fast breeder reactor (LMFBR) plants can be subjected to significant thermal transients during reactor scrams. To reduce local thermal stresses, an insulated “cold” clamp was designed for the fast flux test facility and was also applied to some prototype reactors thereafter. However, the cost minimization of LMFBR requires much simpler designs. This paper presents a “hot” clamp design concept, which uses standard clamp halves directly attached to the pipe surface leaving an initial gap. Combinations of flexible pipe and rigid clamp achieved a self-control effect on clamp-induced pipe stresses due to the initial gap. A 3-D contact and inelastic history analysis were performed to verify the hot clamp concept. Considerations to reduce the initial stress at installation, to mitigate the clamp restraint on the pipe expansion during thermal shocks, and to maintain the pipe-clamp stiffness desired during a seismic event were discussed.
dc.publisherThe American Society of Mechanical Engineers (ASME)
dc.titleHot Clamp Design for LMFBR Piping Systems
dc.typeJournal Paper
dc.journal.volume115
dc.journal.issue1
dc.journal.titleJournal of Pressure Vessel Technology
dc.identifier.doi10.1115/1.2929494
dc.journal.fristpage47
dc.journal.lastpage52
dc.identifier.eissn1528-8978
dc.keywordsClamps (Tools)
dc.keywordsDesign
dc.keywordsPiping systems
dc.keywordsLiquid metal fast breeder reactors
dc.keywordsPipes
dc.keywordsStress
dc.keywordsStiffness
dc.keywordsTest facilities
dc.keywordsThin wall structures
dc.keywordsEarthquakes
dc.keywordsIndustrial plants
dc.keywordsThermal stresses
dc.keywordsEngineering prototypes AND Shock (Mechanics)
dc.treeJournal of Pressure Vessel Technology:;1993:;volume( 115 ):;issue: 001
dc.contenttypeFulltext


Files in this item

Thumbnail

This item appears in the following Collection(s)

Show simple item record