Show simple item record

dc.contributor.authorW. J. Rahmeyer
dc.date.accessioned2017-05-08T23:42:19Z
dc.date.available2017-05-08T23:42:19Z
dc.date.copyrightNovember, 1993
dc.date.issued1993
dc.identifier.issn0094-9930
dc.identifier.otherJPVTAS-28349#406_1.pdf
dc.identifier.urihttp://yetl.yabesh.ir/yetl/handle/yetl/112506
dc.description.abstractUnexpected wear and failure of swing check valves cost power plants and water treatment facilities millions of dollars each year. Operating swing check valves at too low flow velocities can cause the check valve internals to rapidly wear and suddenly fail. Many of the swing check valve failures could have been avoided by the use of a minimum velocity limit or a numerical model to predict the limit of minimum velocity. The following equations and methodology can be used to predict a minimum velocity limit or V MIN for swing check valves. The limit of V MIN is defined as the minimum flow velocity in which the valve disk is fully open and stable without motion. The procedures and equations can also be used to predict the velocity (V OPEN ) to just open the disk to any position or angle. The equations presented in this paper are also unique in that they can be applied to swing check valves that have large degrees of disk position or valve opening. The equations are not limited to swing check valves that must have a portion of the valve disk protruding into the flow through the check valve. Although the methodology was developed primarily for horizontal liquid flows, limited testing has shown that the equations can be applied for installations with inclined slopes and for applications with compressible fluids. The following equations were derived from a large data base of tests of different sizes and types of swing check valves. Tables and figures are presented to support the suggested equations.
dc.publisherThe American Society of Mechanical Engineers (ASME)
dc.titleSizing Swing Check Valves for Stability and Minimum Velocity Limits
dc.typeJournal Paper
dc.journal.volume115
dc.journal.issue4
dc.journal.titleJournal of Pressure Vessel Technology
dc.identifier.doi10.1115/1.2929548
dc.journal.fristpage406
dc.journal.lastpage410
dc.identifier.eissn1528-8978
dc.keywordsStability
dc.keywordsValves
dc.keywordsEquations
dc.keywordsDisks
dc.keywordsFlow (Dynamics)
dc.keywordsWear
dc.keywordsFailure
dc.keywordsDatabases
dc.keywordsFluids
dc.keywordsWater treatment
dc.keywordsMotion
dc.keywordsComputer simulation
dc.keywordsPower stations AND Testing
dc.treeJournal of Pressure Vessel Technology:;1993:;volume( 115 ):;issue: 004
dc.contenttypeFulltext


Files in this item

Thumbnail

This item appears in the following Collection(s)

Show simple item record