Show simple item record

dc.contributor.authorStephen R. Swanson
dc.contributor.authorGlenn E. Colvin
dc.date.accessioned2017-05-08T23:41:31Z
dc.date.available2017-05-08T23:41:31Z
dc.date.copyrightApril, 1993
dc.date.issued1993
dc.identifier.issn0094-4289
dc.identifier.otherJEMTA8-26956#187_1.pdf
dc.identifier.urihttp://yetl.yabesh.ir/yetl/handle/yetl/112028
dc.description.abstractThe compressive strength of fiber composites is of key interest in many strength critical composite structures, due to the generally lower failure values relative to tension dominated stress states. The general understanding of the factors that control compression failure is quite rudimentary, and as a consequence strength controlled design of practical structures loaded in compression can not be accomplished on a rational basis at present. In recent work it has been shown that the compressive strength of the principal load carrying axial plies is markedly affected by the adjacent plies in the laminate. A micro-mechanics model for compression failure of laminates has been formulated that attempts to explain the observed behavior. In the present work a further verification of the model is presented by means of a comparison with experiments performed on laminates with specially treated fiber-matrix interphases. In addition to control specimens using fibers with standard surface treatment, tests were carried out on laminates in which the fibers were treated with a release agent to reduce fiber-matrix adhesion. The specimens with reduced fiber adhesion showed a loss of strength of up to 75 percent, indicating the effects of loss of matrix support. The results show that the model explains a number of important features of the experiments, and thus gives insight into compression failure of laminates.
dc.publisherThe American Society of Mechanical Engineers (ASME)
dc.titleCompression Failure in Reduced Adhesion Fiber Laminates
dc.typeJournal Paper
dc.journal.volume115
dc.journal.issue2
dc.journal.titleJournal of Engineering Materials and Technology
dc.identifier.doi10.1115/1.2904205
dc.journal.fristpage187
dc.journal.lastpage192
dc.identifier.eissn1528-8889
dc.keywordsFibers
dc.keywordsLaminates
dc.keywordsCompression
dc.keywordsFailure
dc.keywordsStress
dc.keywordsCompressive strength
dc.keywordsComposite materials
dc.keywordsDesign
dc.keywordsRelease agents (Additives)
dc.keywordsMicromechanics (Engineering)
dc.keywordsSurface finishing AND Tension
dc.treeJournal of Engineering Materials and Technology:;1993:;volume( 115 ):;issue: 002
dc.contenttypeFulltext


Files in this item

Thumbnail

This item appears in the following Collection(s)

Show simple item record