Show simple item record

dc.contributor.authorD. L. Goodenberger
dc.contributor.authorR. I. Stephens
dc.date.accessioned2017-05-08T23:41:27Z
dc.date.available2017-05-08T23:41:27Z
dc.date.copyrightOctober, 1993
dc.date.issued1993
dc.identifier.issn0094-4289
dc.identifier.otherJEMTA8-26959#391_1.pdf
dc.identifier.urihttp://yetl.yabesh.ir/yetl/handle/yetl/111997
dc.description.abstractThe purpose of this research was to obtain room temperature fatigue behavior of AZ91E-T6 cast magnesium alloy and to determine if commonly used models that depict fatigue behavior are applicable to this cast alloy. Axial strain-controlled fatigue behavior using cylindrical specimens were employed to determine low cycle fatigue behavior with strain ratios R = εmin /εmax = 0, −1, and −2. The conventional log-log total strain low cycle fatigue model properly represented the R = −1 axial fatigue data. Significant mean stress relaxation occurred for all R = 0 and −2 axial fatigue tests. However, for the smaller strain amplitude tests with R = 0, sufficient mean stresses were retained such that fatigue life was reduced. The mean strains/stresses had little influence on the cyclic stress-strain curve which exhibited cyclic strain hardening. Mean stress effects were analyzed using the Morrow, SWT and Lorenzo-Laird models and similar, but oftentimes nonconservative, calculations resulted. Region I and II fatigue crack growth behavior was determined using C(T) speciments with load ratios R = Pmin /Pmax = 0.05 and 0.5. Values of ΔKth and (ΔKth )eff were less than 1.5 MPa m and the Paris equation slopes were between 3.3 and 3.9. Quasi-cleavage was predominant for both fatigue crack growth and final fracture regions. The commonly used low cycle fatigue and fatigue crack growth models appear to reasonably represent most of the results with this AZ91E-T6 cast magnesium alloy.
dc.publisherThe American Society of Mechanical Engineers (ASME)
dc.titleFatigue of AZ91E-T6 Cast Magnesium Alloy
dc.typeJournal Paper
dc.journal.volume115
dc.journal.issue4
dc.journal.titleJournal of Engineering Materials and Technology
dc.identifier.doi10.1115/1.2904236
dc.journal.fristpage391
dc.journal.lastpage397
dc.identifier.eissn1528-8889
dc.keywordsFatigue
dc.keywordsMagnesium alloys
dc.keywordsStress
dc.keywordsFatigue cracks
dc.keywordsLow cycle fatigue
dc.keywordsWork hardening
dc.keywordsFatigue life
dc.keywordsFatigue testing
dc.keywordsStress-strain curves
dc.keywordsFracture (Process)
dc.keywordsEquations
dc.keywordsRelaxation (Physics)
dc.keywordsTemperature AND Alloys
dc.treeJournal of Engineering Materials and Technology:;1993:;volume( 115 ):;issue: 004
dc.contenttypeFulltext


Files in this item

Thumbnail

This item appears in the following Collection(s)

Show simple item record