Show simple item record

dc.contributor.authorH. Sofuog̃lu
dc.contributor.authorJ. Rasty
dc.date.accessioned2017-05-08T23:41:13Z
dc.date.available2017-05-08T23:41:13Z
dc.date.copyrightMarch, 1993
dc.date.issued1993
dc.identifier.issn0195-0738
dc.identifier.otherJERTD2-26448#32_1.pdf
dc.identifier.urihttp://yetl.yabesh.ir/yetl/handle/yetl/111853
dc.description.abstractThe purpose of this study was to simulate the metal extrusion processes via three-dimensional physical modeling technique. Plasticine was utilized as the modeling material, while plexiglass was incorporated in the design and fabrication of a labscale extrusion apparatus. The extrusion setup was designed to accommodate dies of different semi-cone angle while also making it possible to change the extrusion ratio R = A 0 /A f . Cylindrical billets were prepared utilizing alternating layers of two colors of plasticine. Extrusion of cylindrical billets was conducted at three different reduction ratios and three different die angles for each reduction ratio. Dissection of the extruded billets along a centroidal plane revealed the internal deformation patterns which were subsequently utilized for determining the effect of the die angle and extrusion ratio on the state of strain in the final product as well as the required extrusion loads.
dc.publisherThe American Society of Mechanical Engineers (ASME)
dc.titleThree-Dimensional Analysis of Extrusion Process Utilizing the Physical Modeling Technique
dc.typeJournal Paper
dc.journal.volume115
dc.journal.issue1
dc.journal.titleJournal of Energy Resources Technology
dc.identifier.doi10.1115/1.2905967
dc.journal.fristpage32
dc.journal.lastpage40
dc.identifier.eissn1528-8994
dc.keywordsExtruding
dc.keywordsModeling
dc.keywordsStress
dc.keywordsDesign
dc.keywordsDeformation AND Manufacturing
dc.treeJournal of Energy Resources Technology:;1993:;volume( 115 ):;issue: 001
dc.contenttypeFulltext


Files in this item

Thumbnail

This item appears in the following Collection(s)

Show simple item record