• Login
    View Item 
    •   DSpace Home
    • ASME
    • Journal of Energy Resources Technology
    • View Item
    •   DSpace Home
    • ASME
    • Journal of Energy Resources Technology
    • View Item
    JavaScript is disabled for your browser. Some features of this site may not work without it.

    Friction and Wear in Threaded Surfaces of Rotary Drill Collars

    Thumbnail
    View/Open
    JERTD2-26448#23_1.pdf (883.5Kb)
    Date
    1993
    Author
    H. R. Thornton
    E. I. Bailey
    J. S. Williamson
    Metadata
    Show full item record
    Abstract
    Two surfaces, under high normal stress, in sliding contact provide the basis for friction and wear studies within rotary drill collars. Flat and ring specimens, considering three (3) different contact areas, were rotated to determine the effect of surface finish, coatings, lubricants and normal stress on friction and wear. The 4145 steel specimens were heat-treated to a yield strength of 124,000 lb/in2 (855 MPa) and a Rc hardness of 28. The torque required to rotate the ring specimen was measured as a function of the rotation angle. The friction coefficient was calculated. Seizure and galling were common for metal-to-metal contact. Rust and phosphate coatings break down under the high normal stress. Metal-filled lubricants produce static coefficients of friction (μs ) between 0.03 and 0.25 and dynamic coefficients between 0.04 and 0.26. Seizure and galling were not observed.
    URI
    http://yetl.yabesh.ir/yetl/handle/yetl/111852
    Collections
    • Journal of Energy Resources Technology

    DSpace software copyright © 2002-2015  DuraSpace
    Contact Us | Send Feedback
    Theme by 
    @mire NV
     

     

    Browse

    All of DSpaceCommunities & CollectionsBy Issue DateAuthorsTitlesSubjectsThis CollectionBy Issue DateAuthorsTitlesSubjects

    My Account

    LoginRegister

    Statistics

    View Usage Statistics

    DSpace software copyright © 2002-2015  DuraSpace
    Contact Us | Send Feedback
    Theme by 
    @mire NV