Show simple item record

dc.contributor.authorS. Saito
dc.date.accessioned2017-05-08T23:41:10Z
dc.date.available2017-05-08T23:41:10Z
dc.date.copyrightJune, 1993
dc.date.issued1993
dc.identifier.issn0195-0738
dc.identifier.otherJERTD2-26449#117_1.pdf
dc.identifier.urihttp://yetl.yabesh.ir/yetl/handle/yetl/111843
dc.description.abstractWell K6-2 was drilled for geothermal production for the Kakkonda No. 2 Power Plant (to be built in 1995) at the Kakkonda geothermal field, northern Honshu Island, Japan from 1988 through 1989. The well was planned to be vertical and the target area was a 100-m radius of 2800 m. Mainly, because of the formation inclination, strong bit walk tendency was encountered below 1200 m. Even with packed-hole bottom-hole assemblies (BHA), the well inclination buildup rate was over 1 deg per 30 m. With this buildup rate, the well inclination would be over 50 deg at 2800 m, and not only miss the target area, but could not reach total depth because of severe rotation drag in the very abrasive formation (tertiary: shale, dacitic tuff and andesitic tuff-breccia; pre-tertiary: slate, sandstone and andesitic tuff). Because a pendulum BHA did not help to drop the inclination, downhole motors with bent subs were employed. Totals of six and seven downhole motors for 12 1/4 and 8 1/2-in. hole sections, respectively, were run. The estimated formation temperature was over 350°C below 1900 m, so two mud cooling towers and 500 m3 pit were used to cool the returned mud. These systems worked well, but at 2245 m the estimated mud circulation temperature on bottom went up to 150°C and the stator rubber of the downhole motors unbonded and broke up after a 1-h run. Below that depth, only a packed hole BHA was employed, and the inclination increased from 6 deg at 2300 m to 14 deg at 2800 m. At 2799 m, lost circulation was encountered and drilling terminated at 2818 m.
dc.publisherThe American Society of Mechanical Engineers (ASME)
dc.titleThe Drilling Experience of K6-2, the High-Temperature and Crooked Geothermal Well in Kakkonda, Japan
dc.typeJournal Paper
dc.journal.volume115
dc.journal.issue2
dc.journal.titleJournal of Energy Resources Technology
dc.identifier.doi10.1115/1.2905978
dc.journal.fristpage117
dc.journal.lastpage123
dc.identifier.eissn1528-8994
dc.keywordsGeothermal engineering
dc.keywordsDrilling
dc.keywordsHigh temperature
dc.keywordsMotors
dc.keywordsTemperature
dc.keywordsRubber
dc.keywordsDrag (Fluid dynamics)
dc.keywordsPower stations
dc.keywordsCooling towers
dc.keywordsPendulums
dc.keywordsStators
dc.keywordsRotation AND Drops
dc.treeJournal of Energy Resources Technology:;1993:;volume( 115 ):;issue: 002
dc.contenttypeFulltext


Files in this item

Thumbnail

This item appears in the following Collection(s)

Show simple item record