Show simple item record

dc.contributor.authorR. Gourdeau
dc.contributor.authorH. M. Schwartz
dc.date.accessioned2017-05-08T23:40:57Z
dc.date.available2017-05-08T23:40:57Z
dc.date.copyrightMarch, 1993
dc.date.issued1993
dc.identifier.issn0022-0434
dc.identifier.otherJDSMAA-26191#203_1.pdf
dc.identifier.urihttp://yetl.yabesh.ir/yetl/handle/yetl/111728
dc.description.abstractThis paper presents a new adaptive motion control scheme for robotic manipulators. This is an adaptive computed torque method (CTM) that requires only position measurements. These measurements and the input torques are used in an extended Kalman filter (EKF) to estimate the inertial parameters of the full non-linear robot model as well as the joint positions and velocities. These estimates are used by the CTM to generate the input torques. The theory behind Kalman filtering provides clear guide-lines on the selection of the design parameters for the controller when noise is present. Simulation results illustrate the performance of this scheme and demonstrate its noise rejection properties.
dc.publisherThe American Society of Mechanical Engineers (ASME)
dc.titleAdaptive Control of Robotic Manipulators Using an Extended Kalman Filter
dc.typeJournal Paper
dc.journal.volume115
dc.journal.issue1
dc.journal.titleJournal of Dynamic Systems, Measurement, and Control
dc.identifier.doi10.1115/1.2897401
dc.journal.fristpage203
dc.journal.lastpage208
dc.identifier.eissn1528-9028
dc.keywordsAdaptive control
dc.keywordsKalman filters
dc.keywordsManipulators
dc.keywordsNoise (Sound)
dc.keywordsMeasurement
dc.keywordsControl equipment
dc.keywordsRobots
dc.keywordsTorque
dc.keywordsFiltration
dc.keywordsDesign
dc.keywordsMotion control AND Simulation results
dc.treeJournal of Dynamic Systems, Measurement, and Control:;1993:;volume( 115 ):;issue: 001
dc.contenttypeFulltext


Files in this item

Thumbnail

This item appears in the following Collection(s)

Show simple item record