Show simple item record

dc.contributor.authorM. R. Driels
dc.date.accessioned2017-05-08T23:40:53Z
dc.date.available2017-05-08T23:40:53Z
dc.date.copyrightSeptember, 1993
dc.date.issued1993
dc.identifier.issn0022-0434
dc.identifier.otherJDSMAA-26197#560_1.pdf
dc.identifier.urihttp://yetl.yabesh.ir/yetl/handle/yetl/111675
dc.description.abstractThe concept of using a method to constrain the endpoint of a serial linkage (such as a robot manipulator) in order to identify the kinematic parameters is appealing, since it no longer becomes necessary to use ancillary equipment to measure the pose, partial or otherwise. This means that the joint angles obtained from the manipulator and knowledge of the type of constraint, are all that is needed to perform the calibration. This concept is applied to the calibration of a six-degree-of-freedom manipulator by connecting its end point to a table by means of a ball bar. The kinematic equations of the manipulator and constraint are developed, and then used to simulate the calibration process in order to determine whether the noise level present in the measurements disrupts the convergence of the process, the effect of measurement noise on the accuracy of identification and the number of experimental observations needed. The acquisition of experimental data is then described, and the results of the identification are discussed. It is concluded that for certain types of kinematic structures, this method of calibration is particularly attractive since it is rapid, simple to perform, and requires very little precision equipment.
dc.publisherThe American Society of Mechanical Engineers (ASME)
dc.titleUsing Passive End-Point Motion Constraints to Calibrate Robot Manipulators
dc.typeJournal Paper
dc.journal.volume115
dc.journal.issue3
dc.journal.titleJournal of Dynamic Systems, Measurement, and Control
dc.identifier.doi10.1115/1.2899139
dc.journal.fristpage560
dc.journal.lastpage566
dc.identifier.eissn1528-9028
dc.keywordsMotion
dc.keywordsManipulators
dc.keywordsCalibration
dc.keywordsNoise (Sound)
dc.keywordsLinkages
dc.keywordsAccuracy
dc.keywordsEquations of motion AND Measurement
dc.treeJournal of Dynamic Systems, Measurement, and Control:;1993:;volume( 115 ):;issue: 003
dc.contenttypeFulltext


Files in this item

Thumbnail

This item appears in the following Collection(s)

Show simple item record