Show simple item record

dc.contributor.authorE. D. Tung
dc.contributor.authorM. Tomizuka
dc.date.accessioned2017-05-08T23:40:51Z
dc.date.available2017-05-08T23:40:51Z
dc.date.copyrightSeptember, 1993
dc.date.issued1993
dc.identifier.issn0022-0434
dc.identifier.otherJDSMAA-26197#348_1.pdf
dc.identifier.urihttp://yetl.yabesh.ir/yetl/handle/yetl/111642
dc.description.abstractSeveral methodologies are proposed for identifying the dynamics of a machine tool feed drive system in the low frequency region. An accurate identification is necessary for the design of a feedforward tracking controller, which achieves unity gain and zero phase shift for the overall system in the relevant frequency band. In machine tools and other mechanical systems, the spectrum of the reference trajectory is composed of low frequency signals. Standard least squares fits are shown to heavily penalize high frequency misfit. Linear models described by the output-error (OE) and Autoregressive Moving Average with eXogenous Input (ARMAX) models display better closeness-of-fit properties at low frequency. Based on the identification, a feedforward compensator is designed using the Zero Phase Error Tracking Controller (ZPETC). The feedforward compensator is experimentally shown to achieve near-perfect tracking and contouring of high-speed trajectories on a machining center X-Y bed.
dc.publisherThe American Society of Mechanical Engineers (ASME)
dc.titleFeedforward Tracking Controller Design Based on the Identification of Low Frequency Dynamics
dc.typeJournal Paper
dc.journal.volume115
dc.journal.issue3
dc.journal.titleJournal of Dynamic Systems, Measurement, and Control
dc.identifier.doi10.1115/1.2899109
dc.journal.fristpage348
dc.journal.lastpage356
dc.identifier.eissn1528-9028
dc.keywordsControl equipment
dc.keywordsDynamics (Mechanics)
dc.keywordsDesign
dc.keywordsFeedforward control
dc.keywordsMachine tools
dc.keywordsErrors
dc.keywordsSpectra (Spectroscopy)
dc.keywordsPhase shift
dc.keywordsElectromagnetic spectrum
dc.keywordsTrajectories (Physics)
dc.keywordsSignals AND Machining centers
dc.treeJournal of Dynamic Systems, Measurement, and Control:;1993:;volume( 115 ):;issue: 003
dc.contenttypeFulltext


Files in this item

Thumbnail

This item appears in the following Collection(s)

Show simple item record