Show simple item record

dc.contributor.authorA. S. Oddy
dc.contributor.authorJ. A. Goldak
dc.contributor.authorJ. M. J. McDill
dc.date.accessioned2017-05-08T23:39:26Z
dc.date.available2017-05-08T23:39:26Z
dc.date.copyrightFebruary, 1992
dc.date.issued1992
dc.identifier.issn0094-9930
dc.identifier.otherJPVTAS-28333#33_1.pdf
dc.identifier.urihttp://yetl.yabesh.ir/yetl/handle/yetl/110789
dc.description.abstractPrediction of the residual stresses caused by welding is important when post-weld stress relief is not feasible. Phase changes and transformation plasticity have a significant effect on the residual stresses generated by welding and heat-treatment of some alloys. Transformation plasticity occurs when the stresses generated by the transformation of individual grains interact with the macroscopic stress state to produce plastic strains. Heuristic methods requiring empirical constants have been used in the past. A method based on the fundamental laws of plasticity and basic material properties is proposed to incorporate transformation plasticity in a finite element program. The transformation plasticity which occurs depends on the stress state. During any increment the stress state can change substantially. If the step size is too large, the analysis may become unstable. A method which allows larger steps while eliminating the instability and improving the convergence is presented. A three-dimensional (3D) analysis of a short longitudinal pipe weld in a typical pressure vessel steel is shown. The significance of this phenomenon in welds is demonstrated by comparing the residual stress states predicted with and without transformation plasticity.
dc.publisherThe American Society of Mechanical Engineers (ASME)
dc.titleTransformation Plasticity and Residual Stresses in Single-Pass Repair Welds
dc.typeJournal Paper
dc.journal.volume114
dc.journal.issue1
dc.journal.titleJournal of Pressure Vessel Technology
dc.identifier.doi10.1115/1.2929009
dc.journal.fristpage33
dc.journal.lastpage38
dc.identifier.eissn1528-8978
dc.keywordsPlasticity
dc.keywordsMaintenance
dc.keywordsResidual stresses
dc.keywordsWelded joints
dc.keywordsStress
dc.keywordsWelding
dc.keywordsPressure vessels
dc.keywordsHeat treating (Metalworking)
dc.keywordsPhase transitions
dc.keywordsAlloys
dc.keywordsSteel
dc.keywordsMaterials properties
dc.keywordsFinite element analysis AND Pipes
dc.treeJournal of Pressure Vessel Technology:;1992:;volume( 114 ):;issue: 001
dc.contenttypeFulltext


Files in this item

Thumbnail

This item appears in the following Collection(s)

Show simple item record