Show simple item record

dc.contributor.authorJ. Antunes
dc.contributor.authorF. Axisa
dc.contributor.authorM. A. Vento
dc.date.accessioned2017-05-08T23:39:24Z
dc.date.available2017-05-08T23:39:24Z
dc.date.copyrightFebruary, 1992
dc.date.issued1992
dc.identifier.issn0094-9930
dc.identifier.otherJPVTAS-28333#23_1.pdf
dc.identifier.urihttp://yetl.yabesh.ir/yetl/handle/yetl/110788
dc.description.abstractDue to tube-support gaps in heat-exchangers, low-frequency modes may develop and become unstable at comparatively low flow velocities. This kind of linear fluidelastic instability results in a negative modal damping value, which is a function of the flow velocity. The response amplitude of the unstable tubes increases steadily until tube-support impact becomes unavoidable. These extremely nonlinear vibratory motions have a high-risk potential, as tube velocities and impact forces can be of very considerable magnitude. This paper reports results on a series of laboratory experiments, intended to validate nonlinear calculations on vibro-impact dynamics of heat exchanger tube bundles under fluidelastic instability. The test model was designed for unidirectional motion and the results obtained should be fairly representative of the actual behavior of the U-bend portion of the heat exchanger tube bundles. The system instability is generated by a velocity feedback loop. This method presents significant advantages due to simplicity of the setup and the controllability of the system parameters, in particular concerning the negative damping ratio of the unstable model. A comparison of experimental and computed system dynamics is presented for several values of the instability growth rate and for various initial conditions of the motion. Influence of other parameters, such as tube-support gap magnitude and gap symmetry, is asserted for realistically ranged values. Results show that several steady motion regimes may arises, depending on the system parameters and initial conditions of the motion, which is a fact of engineering significance. Furthermore, a satisfactory qualitative and quantitative agreement was obtained between theoretical predictions and test data.
dc.publisherThe American Society of Mechanical Engineers (ASME)
dc.titleExperiments on Tube/Support Interaction With Feedback-Controlled Instability
dc.typeJournal Paper
dc.journal.volume114
dc.journal.issue1
dc.journal.titleJournal of Pressure Vessel Technology
dc.identifier.doi10.1115/1.2929008
dc.journal.fristpage23
dc.journal.lastpage32
dc.identifier.eissn1528-8978
dc.keywordsFeedback
dc.keywordsMotion
dc.keywordsHeat exchangers
dc.keywordsFlow (Dynamics)
dc.keywordsDamping
dc.keywordsSystem dynamics
dc.keywordsDynamics (Mechanics) AND Force
dc.treeJournal of Pressure Vessel Technology:;1992:;volume( 114 ):;issue: 001
dc.contenttypeFulltext


Files in this item

Thumbnail

This item appears in the following Collection(s)

Show simple item record