Show simple item record

dc.contributor.authorA. Chaaban
dc.contributor.authorA. Bazergui
dc.contributor.authorH. Ma
dc.date.accessioned2017-05-08T23:39:24Z
dc.date.available2017-05-08T23:39:24Z
dc.date.copyrightFebruary, 1992
dc.date.issued1992
dc.identifier.issn0094-9930
dc.identifier.otherJPVTAS-28333#19_1.pdf
dc.identifier.urihttp://yetl.yabesh.ir/yetl/handle/yetl/110787
dc.description.abstractThe tube-to-tubesheet joint analysis can be greatly simplified by considering a single tube surrounded by an annular sleeve representing the tubesheet. One of the problems is how to choose the appropriate outer diameter of the annular sleeve model. In this paper, the nonlinear finite element method and some other analytical solutions were used to investigate this problem. Due to the many dimension, fabrication, and material-related parameters, the orthogonal design method was used to minimize the number of calculations while providing an accurate understanding of the influence of all involved parameters. Based on the results, empirical equations for determining the equivalent external sleeve diameter that can be used in the single-tube model and for approximating the residual contact pressure, are proposed.
dc.publisherThe American Society of Mechanical Engineers (ASME)
dc.titleTube-Tubesheet Joint: A Proposed Equation for the Equivalent Sleeve Diameter Used in the Single-Tube Model
dc.typeJournal Paper
dc.journal.volume114
dc.journal.issue1
dc.journal.titleJournal of Pressure Vessel Technology
dc.identifier.doi10.1115/1.2929006
dc.journal.fristpage19
dc.journal.lastpage22
dc.identifier.eissn1528-8978
dc.keywordsEquations
dc.keywordsPressure
dc.keywordsDimensions
dc.keywordsManufacturing
dc.keywordsFinite element methods AND Design methodology
dc.treeJournal of Pressure Vessel Technology:;1992:;volume( 114 ):;issue: 001
dc.contenttypeFulltext


Files in this item

Thumbnail

This item appears in the following Collection(s)

Show simple item record