Show simple item record

dc.contributor.authorF. Hara
dc.contributor.authorT. Iijima
dc.contributor.authorT. Nojima
dc.date.accessioned2017-05-08T23:39:19Z
dc.date.available2017-05-08T23:39:19Z
dc.date.copyrightNovember, 1992
dc.date.issued1992
dc.identifier.issn0094-9930
dc.identifier.otherJPVTAS-28338#444_1.pdf
dc.identifier.urihttp://yetl.yabesh.ir/yetl/handle/yetl/110733
dc.description.abstractThis paper deals experimentally with the comparison of air bubble effects on the vibration of two circular cylinders installed in tandem at pitch-to-diameter ratios of 1.5 and 3.0. Experiments were done for both the pitch-to-diameter ratios changing the void fraction from 0 to about 20 percent for the reduced velocity ranging from 0.5 to 8; vibrational accelerations were measured in both the lift and drag directions for each cylinder and the results were compared with for each other between the pitch-to-diameter ratios of 1.5 and 3. The comparison revealed that 1) the vibration of the tandem two-cylinder system having a pitch-to-diameter ratio of 1.5 or 3 was excited by air bubbles in the flow for small reduced velocity, but the effect of pitch-to-diameter ratio was found in the response characteristics of the upstream cylinder’s vibration in the lift direction; 2) a small amount of air bubbles equivalent to about 4 percent of the void fraction suppressed the strong, out-of-phase vibration in the downstream cylinder of a large P/D of 3 when the reduced velocity was about 7, but the cylinder arrangement with a small pitch-to-diameter ratio of 1.5 showed a weaker vibration reduction due to adding air bubbles in the flow at high flow velocity; and 3) the vibration suppression was likely due to the entrainment of air bubbles in the wake region behind the upstream cylinder.
dc.publisherThe American Society of Mechanical Engineers (ASME)
dc.titleVibration Response Characteristics of Tandem Two Circular Cylinders Subjected to a Two-Phase Cross Flow—Effects of Pitch-to-Diameter Ratio
dc.typeJournal Paper
dc.journal.volume114
dc.journal.issue4
dc.journal.titleJournal of Pressure Vessel Technology
dc.identifier.doi10.1115/1.2929253
dc.journal.fristpage444
dc.journal.lastpage452
dc.identifier.eissn1528-8978
dc.keywordsVibration
dc.keywordsCircular cylinders
dc.keywordsCross-flow
dc.keywordsBubbles
dc.keywordsCylinders
dc.keywordsFlow (Dynamics)
dc.keywordsPorosity
dc.keywordsDrag (Fluid dynamics)
dc.keywordsWakes AND Vibration suppression
dc.treeJournal of Pressure Vessel Technology:;1992:;volume( 114 ):;issue: 004
dc.contenttypeFulltext


Files in this item

Thumbnail

This item appears in the following Collection(s)

Show simple item record