Show simple item record

dc.contributor.authorG. D. Bibel
dc.contributor.authorR. M. Ezell
dc.date.accessioned2017-05-08T23:39:19Z
dc.date.available2017-05-08T23:39:19Z
dc.date.copyrightNovember, 1992
dc.date.issued1992
dc.identifier.issn0094-9930
dc.identifier.otherJPVTAS-28338#439_1.pdf
dc.identifier.urihttp://yetl.yabesh.ir/yetl/handle/yetl/110732
dc.description.abstractUniform bolt stress (±2 percent) was obtained in a one-pass, tension-controlled, bolt-up procedure. This was done by experimentally determining elastic interaction coefficients. The coefficients were then used to solve for the required initial bolt loads that gave the desired final stresses. The procedure worked on two similar pairs of 16-in. class 300 flanges. Each flange set had different interaction, apparently due to surface gaps and misalignment. The procedure was repeated several times with a flat sheet gasket and without a gasket. The procedure and experimental results are described in detail.
dc.publisherThe American Society of Mechanical Engineers (ASME)
dc.titleAn Improved Flange Bolt-Up Procedure Using Experimentally Determined Elastic Interaction Coefficients
dc.typeJournal Paper
dc.journal.volume114
dc.journal.issue4
dc.journal.titleJournal of Pressure Vessel Technology
dc.identifier.doi10.1115/1.2929252
dc.journal.fristpage439
dc.journal.lastpage443
dc.identifier.eissn1528-8978
dc.keywordsFlanges
dc.keywordsStress
dc.keywordsGaskets AND Tension
dc.treeJournal of Pressure Vessel Technology:;1992:;volume( 114 ):;issue: 004
dc.contenttypeFulltext


Files in this item

Thumbnail

This item appears in the following Collection(s)

Show simple item record