Show simple item record

dc.contributor.authorY. Z. Itoh
dc.contributor.authorH. Kashiwaya
dc.date.accessioned2017-05-08T23:39:19Z
dc.date.available2017-05-08T23:39:19Z
dc.date.copyrightNovember, 1992
dc.date.issued1992
dc.identifier.issn0094-9930
dc.identifier.otherJPVTAS-28338#422_1.pdf
dc.identifier.urihttp://yetl.yabesh.ir/yetl/handle/yetl/110729
dc.description.abstractFor investigating the origin of residual stresses in welded joints, the transient thermal stresses in a carbon-manganese-silicon steel (JIS SM41B), a cast martensitic stainless steel (JIS SCS5), an austenitic stainless steel (JIS SUS304), and a titanium alloy (Ti-6Al-4V) were investigated by subjecting round bar specimens, in which both ends were fixed, to thermal of cycles. The specimens were heated in air by high-frequency induction. The cyclic thermal straining tests were conducted for the case of a single thermal cycle and the case of multiple thermal cycles, using a closed loop, servo-controlled testing machine. The experimental results made clear that the transient thermal stress behavior was dependent on metallurgical effects, such as phase transformations, strain hardening, the Bauschinger effect, etc. The effects on phase transformation on the transient thermal stress behavior of SCS5 and SM41B were especially remarkable. However, the effects of phase transformations on the residual stresses due to the thermal straining cycle were negligible in SM41B and not observed in both SUS304 and Ti-6Al-4V. The residual stresses tended to increase with increase of the peak temperature of thermal cycles in SM41B, SUS304 and Ti-6Al-4V. However, when the peak temperature increased above 600°C in SCS5, the residual stress rapidly decreased and became compressive because of the expansion due to the martensite transformation. This study led to the conclusion that the transient thermal stresses for various peak temperatures could easily be obtained by an incremental step test using a single specimen and that this incremental step test could simply estimate the residual stress character of butt-welded joints.
dc.publisherThe American Society of Mechanical Engineers (ASME)
dc.titleA Study of Cyclic Thermal Straining in a Welded Joint, Using a Closed-Loop, Servo-Controlled Testing Machine
dc.typeJournal Paper
dc.journal.volume114
dc.journal.issue4
dc.journal.titleJournal of Pressure Vessel Technology
dc.identifier.doi10.1115/1.2929249
dc.journal.fristpage422
dc.journal.lastpage427
dc.identifier.eissn1528-8978
dc.keywordsMachinery
dc.keywordsServomechanisms
dc.keywordsWelded joints
dc.keywordsTesting
dc.keywordsCycles
dc.keywordsThermal stresses
dc.keywordsResidual stresses
dc.keywordsTemperature
dc.keywordsPhase transitions
dc.keywordsStress
dc.keywordsStainless steel
dc.keywordsWork hardening
dc.keywordsSilicon
dc.keywordsCarbon
dc.keywordsTitanium alloys
dc.keywordsElectromagnetic induction AND Steel
dc.treeJournal of Pressure Vessel Technology:;1992:;volume( 114 ):;issue: 004
dc.contenttypeFulltext


Files in this item

Thumbnail

This item appears in the following Collection(s)

Show simple item record